Tabla de contenido
AMPROBE
When measuring current, always position the wire in the middle of the jaws in order to
obtain the highest accuracy.
A measured value remains constant if the "HOLD" function is active. Should you notice
that the measured value remains unchanged, disable the "HOLD" function.
ν
WARNING:
1.4.
AFTER USE
• After use, turn off the instrument by pressing & holding ON/OFF for a few seconds.
• Remove batteries when the apparatus remains unused for long periods. Please follow
the storage instructions described at paragraph 14.4.
The symbol "
" shows the battery charge: When it is
completely black the batteries are full charged, while the "
symbol indicates weak batteries. When the batteries are too low
to execute a test, the instrument will show a warning message.
In this case, interrupt testing and replace batteries, following the
procedure described in paragraph 13.2. The instrument is
capable of keeping the data stored even though batteries are
not installed. The Instrument Date and Time settings aren't lost
if you change the batteries within 24hours.
MULTITEST2000
"
Capítulos
Tabla de contenido
