Genie CHAINLIFT 1022 Manual De Instrucciones página 24

1. Battery replacement.
• Use coin, ball-point pen or similar device.
-Gently push straight in on battery cover lock
tab as shown (Fig. 8-1).
• Flip open battery cover.
- Remove old battery.
• Make sure new battery is facing proper direction
(Match battery polarity with symbols inside
battery cover) (Fig. 8-2).
- Recommended replacement battery type:
Alkafine A23, 12 volt.
H©K_!; Ss_}_ey_es deft%< i%<},
csye snd s sM,_e_, snce
• Slip new battery into place.
-Snap battery cover shut.
• Operate remote to make sure it is working
properly. (No re-programming is needed.)
2. Visor clip.
You will have to install the visor clip if you
choose to attach your remote to the car visor.
• Slide visor clip into back of remote control.
-It will snap into place (Fig. 8-3).
FIG, 8-1 Open battery cover
For added safety and protection please un
opener before installing light bulb:
1. Light bulb.
• Recommendations.
-Do NOT use a short neck bulb.
-Light bulb should be no more than 60 Watts.
- Use a heavy duty service bulb for longer life.
• Screw bulb into socket.
2. Lens.
• Select the white (lamp) cover. Do NOT use the
colored cover in this location.
• Line up lamp lens tabs on power head with
corresponding slots in lens (Fig. 9-1).
• Slide lens onto power head. Make sure the tabs
are fully engaged into lens slots (Fig. 9-2).
• Plug power cord back into electrical outlet.
Light bulb
Lens tabs
FIG. 9-1 Slide lens onto motor cover.
24
FIG. 9-2
PN# 36420Supplement, 10/27/2008
Fasten lens.