Genie CHAINLIFT 1022 Manual De Instrucciones página 17

There should be no electrical power to the opener
while installing Safe-T-Beam® wire&If you have
plugged in the power cord UNPLUG ITNOW!
NOX8!: Foy Se;sso£s, sc_'-_?s4£wM% a;sd _:nsuh_ed
sS2pFes Mc,_Ae £e_'_. s and _!;a£ 8 ho_. _!;ox 3
1. Mounting brackets.
• Mark both sides of garage door frame or wall no
higher than 6" and no lower than 5" above floor
(Fig. 4-1).
• Hold bracket against door frame or wall.
-Check if brackets extend out from wall far
enough, so tongue of bracket is beyond door,
tracks or any door hardware.
-If not:
a) Mounting bracket extensions are available
through an authorized Genie ® Dealer.
b) Blocks of wood, etc. may be substituted for
extensions.
• Center bracket on your mark (Fig. 4-2).
• Fasten each with 2 screws (Fig. 4-2).
NO_£- _.usd) W bmc£eLs can be a_I'.,_ched_o @e
_fooy' oy' concye_s';_ £ fft_.u,_:_;/n£ concy_s¢®8nchoys
2. Mounting Safe-T-Beam ® Source (Red LED) and
Sensor (Green LED).
• If garage has only one garage door.
- Determine which side of garage receives most
direct sunlight (Fig. 4-4).
-Red LED should always be on sunny side
whenever possible (Fig. 4-4).
• For multiple doors.
-Preventing crossed signals is critical.
-Place source and sensor modules on adjacent
doors facing in opposite directions (Fig. 4-4).
NO'X_!: 70 help p_'eve_s,A f_>_"_?nc e horn su_'_
S__h>..7..Seam senso_' w£h G_<,_enL nay b®
phced F_._'_;se_' away horn the @0_" ®pe_' hW_
ff_ou£h exS:f_.ded _.® f_.__he_' out ho_, _he wsA/,
_#hem £ v;_£ spe;¢d mo;,s ;h_e in s ,_/ow.
• Slide source/sensor onto tongue of bracket until
it clicks into place (Fig. 4-3).
3a. Wiring (If NOT pre-wired).
• Route wire from Safe-T-Beam ®sensors to power
head using method shown in (Fig. 4-5a).
• Securely fasten wires to wall and ceiling ST
as you go (Fig. 4-6 on next page).
-Use insulated staples.
-Staples should be snug only.
Insulated
Staple
FIG. 4'1 Mark door framel
FIG. 4-2
Mounting brackets.
(
ONE DOOR j
GARAGE
FIG. 4-3 Attach
sensors to brackets.
I
TWO DOOR
GARAGE
THREE DOOR
GARAGE
FIG. 4-4 Safe-T-Beam ®source and sensor
locations.
Power
Head
Dashed Line = striped wire
Solid Line = white wire
FIG. 4-5a Source and sensor wiring methods.
I
PN# 36420Supplement, 10/27/2008
17