Genie CHAINLIFT 1022 Manual De Instrucciones página 18

I
3b. Wiring
(pre-wired).
Route wire from wall to Safe-T-Beam ® sensors
(Fig. 4-5b).
Splice pre-wiring to shortened sensor wire,
match wire pairs dash-to-dash and
plain-to-plain.
- Trim sensor wire to approximately one foot
(1 ft) from sensor.
- Split and strip ends of sensor wires and
pre-wired wires (Fig. 4-7).
- Splice wires together with (provided)
wire nuts.
Route wire from ceiling to power head
Wire Nut
(Fig. 4-5b).
Securely fasten wires where they exit tl
wall and ceiling as you go.
-Use insulated staples.
-Staples should be snug only.
Insulated
Staple
Cut or pinched wires can cause the Safe,T-Beam ®
System to stop working: When using the insulated
staples, make sure you fasten them only as tightly
as needed to hold the wire snugly.
4. Split and strip ends of sensor wires (Fig. 4-7).
5. Attach Safe-T-Beam ®wire to power head wire
terminal.
• Route Safe-T-Beam ®wires through wire guide.
-Insert wire into terminal holes and lightly press
in the orange locking clips above each terminal
hole. (You can use a pencil or small
screwdriver to comfortably reach in and lightly
press down locking clips.) Insert white wires to
'even' numbered terminal holes and striped
wires into 'odd' terminal holes (Fig. 4-8).
Locking
i,_s_ Terminal
[_/ Holes
_r_q r_q
r
L.
I I Source
L \ I
Ceiling
_
n
)
Power (
Head
1 '1
I I
1 I
i65
43
21]or165
43
211
Dashed Line = striped wire
Solid Line = white wire
Insert Wire
Wire Into Connector .. .... "'"
', _ Wire
_=_ _1 _ [=_ I, I wire routing
pre-wired
Sensor
S ..... _,,.._.,_....Diij ,r . o,t_ec ,t/o_n g/_,reaea m
Splitting and stripping.
FIG. 4-8
Insert wires.
- Confirm wire lock by lightly tugging on the wire.
The wire should remain in the terminal hole.
• Install rear cover. The rear cover is the same
color as the power head clips and body
(Fig. 4-9).
• Do not install the white (lamp) cover at this time.
poweu (see p_;we S!) O0 HOT PLUG FH YET_
(Power Head With Rear Cover Removed)
Cover clips
FIG. 4-9 Install rear cover.
8 PAl# 36420Supplement, 10/27/2008