Best CP45I Serie Instrucciones De Instalación página 2

Tabla de contenido
Idiomas disponibles

Idiomas disponibles

WARNING
!
TO REDUCE THE RISK OF FIRE, ELECTRIC
SHOCK OR INJURY TO PERSONS, OBSERVE THE
FOLLOWING:
1.
Use this unit only in the manner intended by the
manufacturer. If you have questions, contact the
manufacturer at the address or telephone number
listed in the warranty.
2.
Before servicing or cleaning unit, switch power off at
service panel and lock service disconnecting means
to prevent power from being switched on accidentally.
When the service disconnecting means cannot be
locked, securely fasten a prominent warning device,
such as a tag, to the service panel.
3.
Installation work and electrical wiring must be done by
qualified personnel in accordance with all applicable
codes and standards, including fire-rated construction
codes and standards.
4.
Sufficient air is needed for proper combustion and
exhausting of gases through the flue (chimney) of fuel
burning equipment to prevent backdrafting. Follow the
heating equipment manufacturer's guidelines and
safety standards such as those published by the
National Fire Protection Association (NFPA) and the
American Society for Heating, Refrigeration and Air
Conditioning Engineers (ASHRAE) and the local code
authorities.
5.
When cutting or drilling into wall or ceiling, do not
damage electrical wiring and other hidden utilities.
6.
Ducted fans must always be vented to the outdoors.
7.
Do not use this unit with any solid-state speed control
device.
8.
To reduce the risk of fire, use only metal ductwork.
9.
This unit must be grounded.
10.
When applicable local regulations comprise more
restrictive
installation
requirements, the aforementioned requirements
prevail on those of this document and the installer
agrees to conform to these at his own expenses.
TO REDUCE THE RISK OF A RANGE TOP
GREASE FIRE:
a)
Never leave surface units unattended at high
settings. Boilovers cause smoking and greasy
spillovers that may ignite. Heat oils slowly on low or
medium settings.
b)
Always turn power pack ON when cooking at high
heat or when flambeing food (i.e.: Crêpes Suzette,
Cherries Jubilee, Peppercorn Beef Flambé).
c)
Clean ventilating fans frequently. Grease should not
be allowed to accumulate on fan or filter.
d)
Use proper pan size. Always use cookware
appropriate for the size of the surface element.
and/or
certification
- 2 -
WARNING
!
TO REDUCE THE RISK OF INJURY TO PERSONS IN
THE EVENT OF A RANGE TOP GREASE FIRE,
OBSERVE THE FOLLOWING*:
1.
SMOTHER FLAMES with a close-fitting lid, cookie
sheet or metal tray, then turn off the burner. BE
CAREFUL TO PREVENT BURNS. IF THE FLAMES
DO NOT GO OUT IMMEDIATELY, EVACUATE AND
CALL THE FIRE DEPARTMENT.
2.
NEVER PICK UP A FLAMING PAN — You may be
burned.
3.
DO NOT USE WATER, including wet dishcloths or
towels — This could cause a violent steam explosion.
4.
Use an extinguisher ONLY if:
A. You own a Class ABC extinguisher and you know
how to operate it.
B. The fire is small and contained in the area where
it started.
C. The fire department has been called.
D. You can fight the fire with your back to an exit.
* Based on "Kitchen Fire Safety Tips" published by NFPA.
CAUTION
1.
For indoor use only.
2.
For general ventilating use only. Do not use to exhaust
hazardous or explosive materials and vapors.
3.
To avoid motor bearing damage and noisy and/or
unbalanced impellers, keep drywall spray, construction
dust, etc. off power unit.
4.
Your insert motor has a thermal overload which will
automatically shut off the motor if it becomes
overheated. The motor will restart when it cools down.
If the motor continues to shut off and restart, have the
insert serviced.
5.
The minimum power pack distance above cooktop must
not be less than 24". A maximum of 30" above cooktop
is recommended for best capture of cooking impurities.
6.
Two installers are recommended because of the large
size and weight of this unit.
7.
To reduce the risk of fire and to properly exhaust air,
be sure to duct air outside — Do not exhaust air into
spaces within walls or ceiling or into attics, crawl
space or garage.
8.
This product is equipped with a thermostat which may
start blower automatically. To reduce the risk of injury
and to prevent power from being switched on
accidentally, switch power off at service panel and
lock or tag service panel.
9.
Because of the high exhausting capacity of this unit,
you should make sure enough air is entering the
house to replace exhausted air by opening a window
close to or in the kitchen.
10.
To reduce the risk of fire and electrical shock, the Best
models CP45I & CP47I Series should only be
installed with their own built-in blowers, and the Best
models CP47E Series must only be installed with
Best exterior blower models EB6, EB9, EB12 or
EB15; or Best in-line blowers models ILB3, ILB6,
ILB9, ILB11. Other blowers cannot be substituted.
11.
Please read specification label on product for further
information and requirements.
Tabla de contenido
loading

Este manual también es adecuado para:

Cp47i serieCp47e serie

Tabla de contenido