Best CP45I Serie Instrucciones De Instalación página 10

14. REMOVE THE INTERNAL BLOWER(S)
S B M
INGLE LOWER ODELS
Using a 5/16" socket, a Robertson or a
Phillips no. 2 screwdriver, remove all blower
mounting screws from the inner top of the
power pack. Set aside the screws.
Slide the blower to disengage its flange from
the retaining bracket. Set aside the blower.
D B M
UAL LOWER ODELS
For each blower, using a 5/16" socket, a Robertson or a Phillips no. 2 screwdriver, remove
all blower mounting screws from the inner top of the power pack front and rear brackets.
Set aside the screws.
For each blower, slide it to disengage its flanges from the retaining brackets. Set aside the
blowers.
15. INSTALL THE POWER PACK
Take care not to kink ducting when installing the power pack.
Using provided no. 8 x 1/2" chrome plated screws, install the power pack inside
the custom hood. Start with 2 screws on front corners, then use 4 screws for
sides and use the remaining screws to finalize securing the front power pack.
(See figure beside for mounting screw specific locations.)
Make sure the adapter/damper (or the adapter) enters the ducting. When there
is access to the top of the power pack, seal connections with metal foil duct tape.
(CP45I AND CP47I SERIES ONLY)
L S M
EFT IDE OUNTING
S L
CREW OCATION
HD0269
HD0270
CAUTION
- 10 -
R S
IGHT IDE
M S
OUNTING CREW
L
OCATION
HD0282
B F
LOWERS RONT
B R
LOWERS
HD0297
HD0298
HH0102A
(CONT'D)
B
RACKET
B
EAR RACKET