Best CP45I Serie Instrucciones De Instalación página 16

23. OPERATION
(CONT'D)
• H S ™
EAT ENTRY
This power pack is equipped with a Heat Sentry™ thermostat. This thermostat is a device that will start or speed up the
blower if it senses excessive heat above the cooking surface.
1) If blower is OFF - it turns blower ON to HIGH speed.
2) If blower is ON at a lower speed setting – it turns the blower up to HIGH speed.
NOTE: When Heat Sentry™ is activated, the communication coming from the LinkLogic™ device is disabled and the
"DELAY OFF" function is inactivated.
The HEAT SENTRY™ can start the blower even if the power pack is turned OFF. In this case, it is impossible
to turn the blower OFF with blower switch. If you must stop the blower, do it from the main electrical panel.
When the temperature level drops to normal, the blower will return to its original setting.
• L L ™ N
INK OGIC ETWORK COMPATIBILITY
Your CP45I, CP47I or CP47E Series power pack can be linked to LinkLogic network, if installed in your house.
• L L ™ L
INK OGIC INKING
1. I L
NITIALIZE THE INK
Make sure that the LinkLogic device to be linked is initialized (default state, see instructions of LinkLogic device).
2. A
CTIVATE THE LINK MODE OF THE POWER PACK
Simultaneously press the push buttons 3 and 4 for 2 seconds; all 4 speed level LEDs flash.
L W
INK FOR
R C
EMOTE ONTROL
R
EMOTE
A L
INK MODE OF THE
CTIVATE THE
Push the Link button of the LinkLogic device for
a specific duration to activate its link mode
(see instructions of LinkLogic device).
A
S
TART THE UTO
Press and release push button 4 to start the
Auto-link process, all 4 speed level LEDs
flash in rotation.
NOTE: For some LinkLogic™ devices, LEDs might
not flash because the linking duration is
too short.
E
3. L
XIT MODE OF THE POWER PACK
INK
Press and hold the Exit Link Mode push button (push button 2 on control illustration) for 2 seconds to exit Link mode. Link
mode remains activated for 4 minutes if no other operation is done.
I
NSTRUCTIONS
L
OGIC DEVICE TO BE LINKED
R C ,
ALL EMOTE ONTROL
, F A ™
IRST LERT OR
B M
LOWER ODULES
L L ™
INK OGIC
-L
INK PROCESS OF THE HOOD
L
INK OF ANOTHER
Go back to the appropriate first step if another
LinkLogic device needs to be linked. Otherwise,
to exit Link mode, go to:
Exit Link mode of the power pack.
WARNING
!
S
TART THE
DEVICE
Press push button 3 to start the Master link process,
all 4 speed level LEDs flash in rotation,
meaning that the power pack is waiting for a
SmartSense or Make-Up Air module to Link.
A
CTIVATE THE
Push the Link button of the LinkLogic device
for a specific duration to activate its Link mode.
Wait until the LEDs stop flashing from the power
L L ™
INK OGIC DEVICE
- 16 -
L S S ™
INK FOR MART ENSE
M -U A M
AKE P IR ODULES
M
ASTER LINK PROCESS OF THE HOOD
L
L L
INK MODE OF THE
INK
pack interface to do next step.
OR
™
OGIC DEVICE