Wheels - Honda XRE300 Manual Del Propietário

XRE300 · XRE300A

Wheels

(Refer to the Safety Precautions on page 53.)
This motorcycle is equipped with a side stand only.
Therefore, if front or rear wheel removal is required, it
will be necessary to raise the center of the motorcycle
with a jack or other firm support. If none is available,
see your Honda dealer for this service.
(XRE300A only)
When removing and installing the wheel, be careful not to damage the wheel speed sensor and pulser
ring.
Front Wheel Removal
1. Raise the front wheel off the ground by placing a
support block under the engine.
2. Loosen the axle holder nuts (1).
3. Remove the front axle shaft (2), front wheel and
side collar, then remove the front wheel hub
sensor (3).
(1)
(3)
(2)
(1)
(XRE300A)
Do not depress the brake lever and brake pedal when
the wheel is off the motorcycle. The caliper pistons will
be forced out of the cylinders with subsequent loss
of brake fluid. If this occurs, servicing of the brake
system will be necessary. See your Honda dealer for
this service.
(XRE300)
Do not depress the brake lever when the wheel is off
the motorcycle. The caliper pistons will be forced out
of the cylinders with subsequent loss of brake fluid.
If this occurs, servicing of the brake system will be
necessary. See your Honda dealer for this service.
71
(1) Axle holder nuts
(2) Front axle shaft
(3) Front wheel hub
sensor
(Cont.)