XRE300 · XRE300A
Initial Display
When the ignition switch is turned ON, the liquid
crystal display (1) will temporarily show all the modes
and digital segments.
Thereafter, the speedometer (2) will show from
188 km/h to 0 km/h.
The tachometer (3) will sweep to red zone and go off.
The fuel gauge (4) will sweep to segment F and go off.
This is so that, you can make sure the liquid crystal
display is functioning properly.
Digital clock (5) will reset if the battery is disconnected.
(3)
(1)
(2)
(1) Liquid crystal
(4)
display
(5)
(2) Speedometer
(3) Tachometer
(4) Fuel gauge
(5) Digital clock
Fuel Gauge
The fuel gauge (1) shows the approximate fuel supply
available in a graduated display.
When the segment F (2) goes on, the fuel tank capacity
including reserve is:
12.4 liters (3.28 US gal, 2.73 Imp gal)
When segment E (3) flashes, fuel will be low and you
should refill the tank as soon as possible.
The amount of fuel left in the tank with the vehicle set
upright is approximately:
2.3 liters (0.61 US gal, 0.51 Imp gal)
(2)
(1) Fuel gauge
(2) Segment F
(1)
(3) Segment E
(3)
21