Hilti VC 20-U-Y Manual De Instrucciones página 46

.
en
7.10.1 Charging status display
While the green charge status LED on the charging station lights constantly, if one of the two
charge status LEDs blinks this indicates that charging is in progress.
7.10.2 Indication of too high / too low temperature
The green charge status LED will blink If the battery is too hot or too cold. At the same time, the
LEDs on the battery indicate the charge status of the Li‑ion battery.
7.10.3 Indication of a defective battery
Remove the battery from the charging station If the green status LED on the charging station
lights constantly but all charge status LEDs do not light. If all charge status LEDs on the battery
fail to light even after being activated then the battery is defective. Have the battery tested at a
Hilti center.
7.11 Using the appliance as a transport
trolley
1. Fit the pushbar, following the assembly
instructions provided.
2. Attach the adapter plate, following the as-
sembly instructions provided.
3. Bring the toolbox retaining bar into the
vertical position.
4. Slide the grip of the applicable Hilti toolbox
over the toolbox retaining bar. Make sure
that the lettering on the Hilti toolbox is the
right way up.
5. The toolbox retaining bar and the ribs pre-
vent the toolbox from sliding out of place.
NOTE The
additional load is 25 kg. Do not stack too
many toolboxes one on top of the other.
The toolbox retaining bar must always
project beyond the grip opening in the
uppermost toolbox.
42
LED lights constantly
LED blinks
LED doesn't light
maximum permissible
The appliance is connected to
the electric supply and is ready
for use.
The battery is too cold or too hot
and is not being charged. The
charger switches automatically
to charging mode as soon as
the battery reaches the required
temperature.
Charger malfunction. Unplug
the appliance and then plug it
in again. If the LED still doesn't
light, the appliance should be re-
turned to a Hilti Service Center
for repair.
7.12 Attaching the DPC 20 (for use with
the DG 150 grinder)
1. Fit the pushbar, following the assembly
instructions provided.
2. Attach the adapter plate, following the as-
sembly instructions provided.
3. Make sure that the toolbox retaining bar is
engaged in the horizontal position.
4. Place the DPC 20 in the recess provided.
Make sure that the power outlet is facing
towards the front.
5. Secure the DPC 20 with the rubber straps.