Hilti VC 20-U-Y Manual De Instrucciones página 39

to another. Shorting the battery terminals
together may cause burns or a fire.
i) Under abusive conditions, liquid may be
ejected from the battery; avoid contact.
If contact accidentally occurs, flush with
water. If liquid contacts eyes, additionally
seek medical help. Liquid ejected from the
battery may cause irritation or burns.
j) Do not expose batteries to high tem-
peratures or fire. This presents a risk of
explosion.
k) Do not disassemble, squash or incinerate
batteries and do not subject them to tem-
peratures over 80°C. A risk of fire, explo-
sion or injury through contact with caustic
substances may otherwise result.
l) Avoid ingress of dampness.Dampness
may cause a short circuit resulting in a risk
of burning injury or fire.
m) Do not use batteries other than those
approved for use with the applicable tool
or appliance. Use of other batteries or use
of the battery for purposes for which it is
not intended presents a risk of fire and
explosion.
n) Observe the special instructions applic-
able to the transport, storage and use of
Li-ion batteries.
o) Avoid short-circuiting the battery.Before
inserting the battery in the tool or appli-
ance, check that the terminals of the bat-
tery and the tool or appliance are free from
foreign objects. Short-circuiting the battery
terminals presents a risk of fire, explosion
or contact with caustic substances.
p) Do not charge or continue to use dam-
aged batteries (e.g. batteries with cracks,
broken parts, bent or pushed-in and/or
pulled-out contacts).
5.2.5 Mechanical
Follow the instructions concerning care and
maintenance.
5.2.6 Electrical
a) Insert the plug
earthed/grounded power outlet which
in a suitable
has been correctly and safely installed
and is in compliance
regulations.
b) If you are in doubt about the effective-
ness of the power outlet's earth/ground
connection, have it checked by a quali-
fied specialist.
c) Check the appliance's supply cord at
regular intervals and have it replaced at
a Hilti service center if damage is found.
Check extension cords at regular inter-
vals and replace them if found to be dam-
aged.
d) Check the condition of the appliance and
its accessories. Do not operate the ap-
pliance and its accessories if damage is
found, if the appliance is incomplete or
if its controls cannot be operated fault-
lessly.
e) Do not touch the supply cord or
extension cord if they are damaged
while working. Disconnect the supply
cord plug from the power outlet.
Damaged supply cords present a risk of
electric shock.
f) The electric supply cord may be replaced
only with a cord of the type specified in
the operating instructions.
g) In case of an interruption in the elec-
tric supply: Switch the appliance off and
unplug the supply cord.
h) Avoid using extension cords with mul-
tiple power outlets and the simultaneous
use of several appliances connected to
one extension cord.
i) Use the electric tool power outlet only for
the purposes described in the operating
instructions.
j) Never spray the top section of the va-
cuum cleaner with water: this presents
an electrical hazard and may damage
the appliance.
k) Connectors on mains power cables,
extension cords or supply cords must
provide protection from sprayed water.
l) Grip the plug when unplugging the supply
cord (do not pull or tug at the supply
cord).
m) Never pull the vacuum cleaner by the
supply cord to a new working position.
with local
en
35