Installation Instructions - Cardin Elettronica SL 424EBSS Manual De Instrucciones

Tabla de contenido
Idiomas disponibles
  • ES

Idiomas disponibles

H
300 mm
L
M
I
2
mm
than 1,2 mm.
or bars is over 2,5 m above the ground.
- check the gate components, replace any worn or damaged parts and then
lubricate them.
N
O
not inhibit the gate's sliding action.
- check that a mechanical travel limit Q (absolutely necessary) has been
fitted in the opening direction and that it corresponds to the maximum travel
P
The travel limit must guarantee anti-derailment and gate stability.
Warning! It is the installer's responsibility to check all critical danger
points, to take action and to install any devices needed to guarantee
the safety of all people using the gate (risk analysis).

INSTALLATION INSTRUCTIONS

passageway.
Important
UNIT
Anchoring the unit (fig. 4, 5, 6)
Important! Check the exact anchoring position with respect to the alignment
of the sliding gate.
be installed.
40 mm and then tighten down using the supplied M8 nuts.
with a depth of 350 mm (the base should protrude by about 25 mm to avoid
damage by pools of water building up under the appliance).
C
is perfectly level;
- the four protruding 50 mm threaded bolts are perpendicular to the base
plate;
- the surface area of the base plate is clean and free of cement residue.
4
B
C
1
2
5
I
L
P
INSTRUCTIONS FOR POSITIONING THE
A
B
M 8
A
3
4
300
If the runner guide already exists the cement base should be extended to
12 mm
take in part of the runner guide foundation. This will stop the two foundations
from giving way separately.
2,5
- Unscrew the four M8 nuts on the four threaded bolts (previously used to block
the anchor bolts) and leave a space of 15 mm between the anchor plate and
the base of the motor. Then insert the four washers and allow them to rest on
the nuts.
- Position the geared motor over the four threaded bolts and allow it to rest on
the four washers.
- Fasten it to the base using the other four washers and adjustment nuts supplied
with the kit, making sure that the unit remains perfectly level and stable.
This will allow you to adjust the height and position of the motor later on.
Fitting the toothed rack
5
- release the geared motor (fig. 8), lay the first stretch of the toothed rack on the
pinion and fix it to the gate, then fasten down all the other parts along the entire
length of the gate.
- after having fastened the toothed rack, realign the pinion (play of 1 to 2 mm
between the toothed runner and the pinion) using the positioning nuts at the
base of the geared motor. This action will prevent the weight of the sliding gate
from damaging the unit when working.
Attention!
You must respect the distance of 15 mm between the anchor plate
and the base of the motor.
6
2 mm
15 mm
5
15
70
Tabla de contenido
loading

Tabla de contenido