Centrometal CentroPelet ZV16 Instrucciones Técnicas página 56

CLEANING BY THE TECHNICAL
Check every year
Compartment ventilation flue gas cleaning
Remove the fixing screws and remove the
smoke fan for cleaning of the same. Perform the
task with the greatest care not to bend the fan
blades.
Clean flue
Clean the flue system especially near the fittings
to "T", curves and any horizontal sections. Is
necessary to check and remove any deposit of
ash and soot before the same clogging the pas-
sage of smoke.
Cleaning the exchanger
Once a year is also recommended to clean the
upper compartment of the exchanger. To make
a proper cleaning is recommended to suck the
ash, remove all horizontal joints with a screw-
driver, then again suck the ash.
Lift the upper door that covers the tube by un-
screwing the screws. Pull out the 10 soft brush
and wipe with a clean 10 exchanger tubes.
Perform cleaning after removing the springs in-
serted in each pipe. The operation is simple by
removing the springs from the horizontal pin to
which they are attached.
To do this, the horizontal pin can be pulled
through a hole in the wall of the thermostove
body.
56
1
2
Now the upper sec-
tion to the heat ex-
changer is free from
any encumbrance so
as to allow a perfect
cleaning.
Following the cleaning
compartment of
section, store the
This cover must be closed, as well as with
normal screws, with webbing in ceramic fiber
rope to ensure the watertight closure of the
thermostove.
This general cleaning should be carried out at
the end of the season in order to facilitate the
general removal of all residues of combustion,
without waiting too long, because with time and
humidity these residues can become compacted.
Check the seal of the ceramic fiber gaskets on
the door of the thermostove.
Then clean the flue system especially near the
fittings to "T" and any horizontal sections.
For your safety, the frequency of
cleaning the smoke discharge sys-
tem must be determined on the ba-
sis of how the thermostove is used.
The transaction must
completed by unscrewing
with a screwdriver the fixing
bushes (photo 1).
Remove the screws holding
the cleaning kit to the cam-
era body and pull it com-
pletely (photo 2-3).
of the upper
the exchange
upper closure cover.
be
3