Remote Control - Centrometal CentroPelet ZV16 Instrucciones Técnicas

REMARKS:
- the appliance must be installed by a qualified technician in possession of the technical and
professional requirements according to the DM37/2008 that, under its responsibility, to ensure
compliance with the rules of good technique.
- the thermostove must be connected to a heating system and/or to a network of production of
sanitary hot water, consistent with its performance and its power
- you need to keep in mind all laws and national, regional, provincial and municipal laws of the
country in which you installed the device
- check that the floor is not flammable: if necessary use a suitable platform
- in the room where the generator must be installed to heat must not pre-exist or be installed with
an extractor hood or ventilation ducts of the collective type.
Should these devices be located in adjacent rooms communicating with the installation, and
'prohibited the simultaneous use of the heat generator, where there is a risk that one of the two
rooms being placed in depression than the other
- it is not permissible to install in bedrooms or bathrooms
- for hydraulic connections (see next chapter) it is advisable to use where possible of hoses

Remote Control

The remote control (Fig. 3) used to adjust water temperature
power and the on/off functions for the pellet thermostove.
To start the thermostove, press key and the stove will
automatically enter the starting phase.
+ -
Press keys (1) and (2) to adjust temperature, and
+ -
use keys (6) and (5) to adjust operating power.
To turn off the thermostove, hold down key .
To replace the 3 volt battery located on the back of the
remote control, pull the centre of the cover and the lever
on the side of the same, replace the battery observing the
correct polarity (Fig. 4)
Fig. 3 Fig. 4
39