Connection To The Power Supply - Foster S4000 Manual De Instrucciones

Installing the foam
gasket
Installation procedure

CONNECTION TO THE POWER SUPPLY

Basic adjustment of
sensors to the ambience
User interface initial
calibration
Before inserting the appliance into the opening in the kitchen worktop, the
supplied foam gasket must be attached to the lower side of the glass ceramic
(glass) cooking hob.
Do not install the appliance without the foam gasket!
The gasket should be attached to the appliance in the following way:
▪ Remove the protective film from the gasket.
▪ Then, attach the gasket to the lower side of the glass, approximately 2-3
millimetres from the edge.
▪ The gasket must be attached along the entire length of the glass edge and
should not overlap at the corners.
▪ When installing the gasket, make sure that the glass does not come into
contact with any sharp objects.
• Worktop must be placed absolutely horizontal.
• Suitably protect the edges of the cut aperture.
• Connect the cooking hob to the mains power supply (see instructions for the
connection of the cooking hob to mains power supply).
• Insert the hob into the cut aperture.
• Press the hob firmly towards the worktop from above.
• Connections may be carried out by a qualified technician only. The earthing
protection must comply with the standing regulations.
• Connection terminals are revealed when the connection box cover is removed.
• Prior any attempted connection check that the voltage indicated on the rating
plate is in line with your home power supply.
• The rating plate is located underneath the appliance.
• The appliance is manufactured for use with the power supply voltage
220-240 V ~.
• The electric wiring should be equipped with a circuit breaker able to isolate the
appliance from the mains in all points, with the distance between terminals of at
least 3 mm in open position. This may be done by means of fuses, safety
switches, etc.
• The connection should be selected in accordance with the declared charge
capacity of the mains and the fuse power.
• Such appliances are allowed to be mounted on one side next to a high kitchen
cabinet, the height of which may exceed that of the appliance. On the opposite
side however, only a kitchen cabinet of equal height as the appliance is allowed.
• Upon the completion of installation, live wires and isolated cables must be
adequately protected against accidental touching.
Upon each connection to the power supply the sensors of the appliance are
automatically adjusted to the environment to ensure their proper function. All
displays turn on and are fully illuminated for a few seconds.
During the adjustment procedure the sensors must be free of any objects,
otherwise the adjustment procedure will be interrupted until such objects are
removed from the sensor surface. During this period the regulation of the
cooktop is impossible.
The hob control panel has implemented an initial keyboard calibration focused to
adapt the sensibility of the keys, to the final mechanical, environmental and user
conditions.
Any time the cooking hob is plugged in or there is a power failure that results in a
reset of the user interface, keyboard sensitivity will be readjusted the first time
the Key Lock is touched. This first touch of the Key Lock must be done in certain
conditions:
▪Do not use gloves
▪Use a clean finger.
▪Touch the glass (smooth touching).
20