Accurately clean milling.
Before positioning the top, lay the
sealer gasket provided on the entire
milling surface [
Once these operations have been
completed, use the supplied brackets
to fasten the hob to the structure. Re-
fer to the "Fastening the cooker
hob to the cabinet" paragraph
[
Page 27
A constant light of at least 0.5 mm is envisioned between the external dimensions of the
stainless steel platform and the internal dimensions of the lowering that must be respected
during assembly. The temperatures that develop during use of the cooker hub induce a
slight elongation on the stainless steel platform, therefore, the envisioned light enables
avoiding any interferences. With regard to the kitchen worktop, the temperatures induced
by the cooker hub - whether in the section and on the contact top - are very contained.
We recommend assembling the cooker hubs with flush-mount edge on water-repel-
lent materials.
7.
Fastening the cooker hob to the cabinet
Fasten the supplied hooks to the brackets under the appliance, as shown here below.
The supplied hooks make it possible to fasten to a top whose thickness is between
30 and 40 mm.
IMPORTANT:
For fastening this product to the support structure, the use of mechanical or
electric screwdrivers is not recommended and only moderate pressure
must be exerted by hands to the clamping parts.
The surface under the appliance must be at at least 5 mm from the bottom of it
and must have an opening for passing gas and electric conduit that is
at least 50x50 mm.
If this product is installed above an oven, it must be equipped with a
cooling fan.
].
Fig. 5
].
INSTALLER INSTRUCTIONS
Fig. 5: positioning the insulating gasket
27