Turning Off - BERTO'S PLUS 600 Serie Manual De Instrucciones

70 |
Ignition of the pilot burner (Fig. 6)
Press the handle (4) and rotate it anticlockwise to the "pilot"
position (3). Keep the knob pressed in and simultaneously
press the button of the piezoelectric ignition (6) up to
when the pilot flame lights up. Make sure the pilot flame
is on through the slot (10) on the control panel. Keep
the knob pressed in for about 15-20 seconds; if the pilot
flame turns off after releasing the knob, repeat the ignition
operation.
Main burner ignition and temperature regulation (Fig. 6)
Switching on the main burner and regulate the
temperature (see Fig. 6)
To switch on the main burner, rotate the knob again
anticlockwise until you get to the desired temperature.
The thermostat is marked in positions from
approximate values of temperature for each position are
EN
the following:
Turning off during normal operation (Fig. 6)
If only the main burners need to be turned off; turn
the knob to the
pilot flame is turned on. To switch the entire installation
completely off, turn the handle to
What to do in case of malfunctioning or if the appliance
is not used for a long period of time
If the appliance is not to be used for a long period of time,
or in the event of a failure or malfunctioning, turn off the
external gas supply tap connecting to the main line. After
performing all cleaning operations, the stainless steel
surfaces should be well dried and protected with standard
anti-corrosion products. In the event of a failure, call
Technical Assistance.
TAKING CARE OF THE APPLIANCE
ATTENTION!
Allow the appliance to cool down before cleaning.
Giving the appliance a thorough cleaning every day will
keep it in perfect working order and make it last longer. All
steel parts should be cleaned with a dish detergent diluted
in very hot water, using a soft cloth; to remove stubborn
dirt, use ethyl alcohol, varnish remover or another non
halogen solvent; do not use abrasive powder or corroding
detergents, such as hydrochloric/muriatic or sulphuric
acid. The use of acids can compromise the functionality
and safety of the appliance. Do not use brushes, steel
IGNITION
to
Position degrees °C
160
2 170
3 185
4 200
5 215
6 235
7 260
290

TURNING OFF

position; in this position, only the
/ .
MOD.
wool or abrasive pads made with other metals or alloys
Qn
that might leave traces of rust. For the same reason,
V kW:
avoid touching the appliance with anything made of iron.
Pay attention to use steel wool pads or stainless steel
brushes that do not cause rust but may cause damaging
scratches. If the appliance is extremely dirty, do not use
emery or sandpaper. As an alternative, we recommend
using a synthetic sponge (for example, the Scotchbrite
sponge). Do not use substances used to clean silver
and pay attention to hydrochloric or sulphuric acid that
might have been used to clean the floor. Never clean the
appliance with jets of water. After cleaning, properly rinse
the appliance with clean water and use a cloth to dry it
carefully.
; the
N°:
Hz: 50/60 IPX2