Tabla de contenido
Idiomas disponibles
Idiomas disponibles
4. Disassemble the hook block.
4.1 Remove the rubber plate or the
magnetic limit switch activator (2) from
the top of the hook block on the hook
end of the chain.
4.2 Remove the rubber cover (1) of the
hook block by pulling the rubber cover
upwards.
4.3 Remove the screws (4). Open the
hook block (3).
4.4 Remove the pin (5) from the chain.
4.5 Pull out the chain.
5. Remove the chain from the chain hoist by driving the motor in the direction UP.
6. Insert the new chain by using the plastic
chain insertion tool.
6.1 Attach the chain to the chain insertion
tool.
6.2 Place the chain insertion tool to the
chain output on the load side of the
chain fall.
6.3 Feed the chain insertion tool into the
chain guide.
Insert the chain insertion tool into
the chain hoist and guide it through
the chain guide in the correct
position. The tip of the chain
insertion tool should point towards
NOTA
the chain sprocket (towards the
back of the chain hoist). Feeding
the chain insertion tool into the
chain guide in an incorrect position
can damage the chain sprocket.
6.4 Drive the motor in the direction UP so
that it pulls the chain inside the chain
hoist.
Este documento y la información contenida en éste son de propiedad exclusiva de Verlinde S.A.S., constituyen un
secreto comercial no público, confidencial del propietario, y no puede ser ni reproducido, divulgado a terceros,
modificado ni empleado de ninguna otra manera sin el permiso expreso escrito de Verlinde S.A.S. Copyright 2020 ©
Verlinde S.A.S. Todos los derechos reservados.
1
5
7 MAINTENANCE
2
3
4
3/2020
Tabla de contenido
