Special Cuts; Cutting Bowed Material; Cutting Round Or Irregularly Shaped Material - Bosch 4405 Instrucciones De Funcionamiento Y Seguridad

Cutting Bowed Material

If workpiece is bowed or warped,
!
WARNING
clamp it with the outside bowed
face toward the fence. Always make certain that there
is no gap between the workpiece, fence and table
along the line of cut. Bent or warped workpieces can
twist or rock and may cause binding on the spinning
saw blade while cutting (Figure 35).
Cutting Round or Irregularly
Shaped Material
For round material such as dowel
! WARNING
rods or tubing, always use a clamp
or a fixture designed to clamp the workpiece firmly
against the fence and table. Rods have a tendency to
roll while being cut, causing the blade to "bite" and
pull the work with your hand into the blade (Figure 36).
Saw Operations

Special Cuts

31.
Workpiece
Clamp
Figure 35. Bowed Material
Workpiece
Clamp
Fence
Figure 36. Round Material
No Gap at
This Point
Bowed
Material
Round
Material