Positioning And Growth Adjustments; Tools You Will Need; Seat Depth Adjustment (Moderate); C.seat Depth Adjustment (Advanced) - Sunrise Medical Zippie VOYAGE Manual De Instrucciones

Z IPP IE VO YA GE
A. POSITIONING AND GROWTH ADJUSTMENTS
If a change in adjustment is necessary for growth or positioning, a healthcare professional
must be consulted before any changes are made. These adjustments are very important to
the orthopedic and neurological needs of the child. Care should be taken to make sure the
changes are physiologically and medically appropriate. Sunrise Medical suggests that any
positioning or growth adjustments be made by your service provider. Do not allow any
adjustments while the child is seated in the mobility device.

TOOLS YOU WILL NEED

To set-up, adjust and maintain your device you will need the following tools:
1. 4mm hex key for most growth adjustments on the Voyage.
2. 5/32 hex key (for headrest collar adjustments)
3. 10mm open end wrench
4. Torque Wrench
If you plan to adjust and maintain this device yourself, Sunrise recommends that you use a
torque wrench.
NOTE - The torque wrench must measure inch-pounds. You may buy a torque wrench and proper
metric sockets from any local hardware store.
In general, positioning and growth adjustments should be done in the following order:
1. Adjust seated area
2. Adjust back support area
3. Adjust pelvic positioning belt
4. Adjust
footplate
5. Adjust head support(s)
6. Make other standard and optional adjustments that are needed
7. Check to be sure that all adjustment screws are torqued to specifications
B. SEAT DEPTH ADJUSTMENT (MODERATE)
a. Start by determining the proper seat cushion depth.
b. Remove the seat cushion. It is attached with Velcro®.
c. Loosen the screws (A) on both sides (do not remove)
d. Loosen the four nuts (B). The hardware may need to be removed for
certain adjust-ments.
e. Adjust the depth by sliding the front of the seat pan forward, or backwards.
f. Re-tighten hardware (A) and (B) to
the cushion.
C. SEAT DEPTH ADJUSTMENT (ADVANCED)
a. Start by determining the proper seat cushion depth.
b. Remove the seat cushion. It is attached with Velcro®.
Adjusting Seat Pan to increase depth.
a. Loosen the screws (A) on both sides, found at the ends of the sideframe.
b. Loosen the two screws (B) that hold the seat pan in place.
c. You can slide the combination of seat pan and footrest platform to adjust the seat
depth. Tighten the screws.
d. If more depth is needed loosen the assymmetric leg plates (C) and move forward to
appropriate depth. Tighten the screws.
MK-100377 Rev. A
WARNING
29
(75-85 in-lbs, 8.5-9.5 Nm) and re-attach
30 31
18
IX. DEALER SERVICE & ADJUSTMENT
29
30
31