D.adjusting The Back Angle For Angle-Adjustable Backrest; Arms; A.removing Flip-Back Armrest; B.removing And Positioning Flip-Back, Height-Adjustable Armrest - Sunrise Medical Breezy Manual De Instrucciones

22
D. ADJUSTING BACK ANGLE FOR ANGLE-ADJUSTABLE BACKREST (FIGURE 16)
1. Slightly fold chair.
2. Remove rear wheel. Refer to Wheelchair Basics Section 3 of this manual.
3. Remove hex bolt and hardware (H).
4. Using one of the pre-configured angle adjustment slots, (I) reposition the angle-
adjustable bracket hardware (J) by moving it up and down.
5. Securely reattached the hex bolt and hardware (H) with the head of the bolt facing
outward from the wheelchair, and the adjustment knob facing inward.
6. Repeat instructions for opposite side.
CAUTION- Angle-adjustable back should be the same degree on both sides before using the
wheelchair.
After ANY adjustment, repair or service and BEFORE use, make sure all attaching
hardware is tightened securely – otherwise injury or damage may result.
A. REMOVING FLIP-BACK ARMREST (FIGURE 17)
1. Press the armrest release lever located on the armrest (A).
2. Flip the armrest back (B).
3. Pull release knob (C) out that attaches the arm to the rear receiver. Pull armrest up
and out to remove.
4. Replace the armrest by reversing STEPS 1-3. Confirm that the armrest lever (A) is
fully engaged to front receiver before using wheelchair.
B. REMOVING AND POSITIONING FLIP-BACK HEIGHT ADJUSTABLE ARMREST
(FIGURE 18)
1. To remove the armrest assembly follow same steps in Section A of Arms listed above.
2. To adjust the vertical position of the arm pad, use release knob (D) to adjust height.
Pull the release knob out with one hand and use the other hand on the horizontal
arm pad (E) move the arm up and down. Allow the release knob to fully engage into
the pre-configured positions once desired height is obtained.
After ANY adjustment, repair or service and BEFORE use, make sure all attaching
hardware is tightened securely – otherwise injury or damage may result.
Caster should always be adjusted or repaired by an authorized dealer.
A. CASTER JOURNAL ANGLE ADJUSTMENT (FIGURE 19)
1. Whenever there is an adjustment to the seat-to-floor height (STFH), the angle of the
caster should be checked to make sure its leading edge is perpendicular to the
ground. Perpendicular orientation will guard against flutter.
2. To adjust the angle of the front caster journal remove the two eccentric bolts (F) and
retighten when the leading edge of the journal is perpendicular to the ground.
930853 Rev. B
E n g l i s h

ARMS

WARNING

CASTERS

WARNING
WARNING
I X . S e t - U p , A d j u s t m e n t & U s e
H
C
H
16
J
I
17
B
A
18
E
D
19
G
F