TRAPP ES-500 Manual De Instrucciones página 49

www.trapp.com.br
Notes:
Fit the male and female parts of the cardan

shaft and attach the female side to the shaft of
the power take-off shaft of the shredder, and
then attach the male cardan shaft to the shaft
of the tractor power take-off until it clicks,
showing that it is in the correct position on
both sides.
After assemble and adjusting the guard chain,

move the tilt of the tractor hydraulics and
check the clearance between the male and
female cardan positioning the machine at the
recommended inclination of at most 15°.
These operations must only be carried out on

suitable ground and only after stopping the
tractor, turning off the power take-off and
pulling the parking brake. If necessary, lift the
machine above the ground. But for everyone's
safety, place it on a stand, thus avoiding any
accident that could be caused by a sudden
fall.
Electric
All TRAPP Shredders, single-phase or three-phase,

are assembled with dual voltage motors. They leave
factory without electrical connection to allow the
customer to choose the kind of connection based
on the voltage of their property power source.
For shredders sold without motor, the choice of

the minimum power shall follow the technical data
shown on pg. 44.
For motors of power higher than 5cv, it is

recommended to use a delta-star switch to
start them. The model suggested is ETW (WEG
Acionamentos) or a similar one.
As the on/off switch is distant from the shredder,

install an emergency button in the equipment in
case immediate switching off is necessary.
Measurement of the cut
Dividing the measurement found between shafts by 1.3 will
provide the measure to cut the cardan shaft.
Measure between cardan shafts
Trim plastic
protection
3 cm
Image merely illustrative
Figure 5
Motor Installation
Before making any kind of connection,
make
disconnected.
1. Make sure that the power source where the
2. Disconnect the power source to make motor
3. Make the connections shown on the
4. Make sure the connections are well insulated.
5. Turn on power source and check the
= Measure A
1.3
Attention!
sure the power
shredder will be installed is compatible with
the data on the motor plate.
connections.
nameplate of the wiring diagram on the
motor according to the mains voltage.
rotation of the motor. If necessary, reverse
the electrical connection as indicated on
the motor nameplate so that it works in the
correct direction of rotation.
Measure the
end of the
cardan shaft
source is
49