Set-Up, Operation; Emission Levels; Setting Up The Machine; Prior To Initial Operation - Festool PRECISIO CS 70 EBG Manual De Instrucciones

5.4

Emission levels

Typically, the noise levels that are determined in
accordance with EN 62841 (see EC declaration of
conformity) are as follows:
Sound pressure level
Sound power level
Measuring uncertainty allowance
CAUTION
The noise produced during work may damage
your hearing.
fWear ear protection!
- The specified noise emission levels have been
measured in accordance with the standard test-
ing method and can be used to compare tools.
- The specified noise emissions can also be used
for making preliminary estimates regarding
noise load.
CAUTION
The noise emissions during actual use of the
power tool can differ from the declared val-
ues depending on the ways in which the tool
is used especially what kind of workpiece is
processed.
fIdentify safety measures to protect the oper-
ator that are based on an estimation of ex-
posure in the actual conditions of use (tak-
ing account of all parts of the operating cycle
such as the times when the tool is switched
off and when it is running idle in addition to
the trigger time).
5.5

Other risks

In spite of compliance with all relevant design
regulations, dangers may still present them-
selves when the machine is operated, e.g.:
- Workpiece parts being thrown off,
- Parts of damaged tools being thrown off,
- Noise emissions,
- Wood dust emissions.
26
6
Risk of accident if the machine is operated us-
L = 84 dB(A)
ing the incorrect voltage or frequency.
PA
L = 98 dB(A)
WA
fThe line voltage and frequency of the power
K = 3 dB
fOnly Festool machines with a rated voltage of
fBefore use always inspect the flexible lead
fOutside the premise use only approved ex-
6.1
Ensure that the floor around the machine is lev-
el, in good condition and free of loose objects
(e.g. chips and offcuts).
L
fTo unfold the legs: Loosen the four rotary
fUnfold the legs [1-1] and tighten the rotary
If the machine wobbles, the length of one leg can
be adjusted by turning the end cap [1-12] until
the machine stands securely.
6.2
6.2a
fScrew the supplied rotary knob [2-6] anti-
6.2b
fRemove the yellow safety sticker [12-4].
fSet the saw to maximum cutting depth and the
fPull the riving knife [12-1] into the upper po-
f
f
f

Set-up, operation

WARNING
supply must match those specified on the
machine's rating plate.
120 Volt may be used in North America.
and the plug. Have the defects repaired by a
specialist repair shop.
tension leads and cable connections.

Setting up the machine

The machine can be set up with or without
the legs unfolded.
knobs [1-11] all the way.
knobs [1-11] again.

Prior to initial operation

Fitting the knob
clockwise into the guide rod.
Installing the guard (fig. 12)
mitre to 0°.
sition.
1
Take hold of the guard [12-3] and com-
pletely unscrew the screw [12-2].
2
Place the guard [12-3] on the riving
knife [12-1]. In doing this, guide the length-
wise pin that is located in the guard [12-3] into
the groove [12-6] on the riving knife [12-1]
and push the screw [12-2] into the hole [12-5]
in the riving knife [12-1] and tighten it.
3
Tighten the screw [12-2].
-
P R E C I S I O GB