Operation; Changing The Battery Pack; Charging The Battery Pack - Festool CARVEX PSC 400 EB Manual De Instrucciones

Changing the battery pack [2]

Removing the battery pack
X
Press and hold the two buttons [2-1].
X Slide the battery pack forwards to remove.
2
Inserting the battery pack
X
Slide the battery pack onto the retainer on the
underside of the handle shown in Fig. until it en-
gages.
L The cordless jigsaws can be used with all Fes-
tool battery packs of the BPS series.
Risk of injury! Always remove the belt clip
from battery packs from the BPC series pri-
or to use.
2
10
All manuals and user guides at all-guides.com

Operation

L The battery pack is delivered partially charged.
The charger TRC 3 can be used to charge all Festool
battery packs of the BPS and BPC series. The
charger automatically detects the type of the in-
serted battery (NiCd, NiMH or LiIon). A micropro-
cessor controls the charging process in line with
the charging state, temperature and voltage of the
battery pack.
The LED [3-1] on the charger indicates the respec-
tive operating status of the charger.
2-1
LED yellow - lit continuously
Charger is ready to use.
LED green - flashing quickly
Battery pack is charged to maximum capacity.
LED green - flashing slowly
Battery pack is charged with reduced current, LiIon
is charged to 80 %.
LED green - lit continuously
Battery pack is fully charged, or charging is not
started again, because the battery is charged to
more than 80 %.
LED red - flashing
klick
General fault display, e.g. incomplete contact, short
circuit, battery pack faulty, etc.
LED red - lit continuously
Battery temperature is outside the permitted
range.

Charging the battery pack [3]

To guarantee the full battery power, charge it
completely before using it for the first time.
3
3-1