About The Surface; To Stop The Product; To Start A Warm Engine; To Use The Product - Husqvarna 525DEPS Manual Del Usuario

4. Slowly pull out the starter rope with your right hand
until you feel some resistance (the starter pawls
grip).
WARNING: Do not twist the starter rope
around your hand.
5. Pull the cord quickly and with power.
CAUTION: Do not pull the starter rope all
the way out and do not let go off the
starter rope handle when the starter rope
is fully extended. This can cause
damage to the product.
6. Pull the starter rope until the engine starts or for a
maximum of 5 times.
7. Reset the choke when the engine starts or after you
pull the starter rope 5 times.
8. If it is necessary, pull the starter rope again and
again until the engine starts.
9. Let the engine run for 10 seconds.
10. Operate the throttle gradually.
11. Make sure the engine runs smoothly.
Note: If the engine stops, do the procedure again.

About the surface

WARNING: Do not put parts of your body in
the grey marked area. If you touch the grey
marked area it can result in burns to the
skin. It can also cause electrical shock if the
spark plug cap has been damaged. Do not
use a product with a damaged spark plug
cap.

To start a warm engine

WARNING: Read the warning instructions in
the safety chapter before you start the
product (refer to
1. Use protective gloves.
2. Push the air purge bulb 10 times.
1480 - 003 - 05.08.2020
Safety on page 4 ).
3. Hold the body of the product on the ground with your
left hand.
CAUTION: Do not use your feet!
4. Hold the starter rope handle with your right hand.
5. Slowly pull out the starter rope with your right hand
until you feel some resistance (the starter pawls
grip).
WARNING: Do not twist the starter rope
around your hand.
6. Pull the cord quickly and with power.
CAUTION: Do not pull the starter rope all
the way out and do not let go off the
starter rope handle when the starter rope
is fully extended. This can cause
damage to the product.
7. Pull the starter rope again and again until the engine
starts.

To stop the product

1. Move the stop switch into the stop position to stop
the engine.
CAUTION: The stop switch automatically
goes back to its initial position. In order
to prevent accidental starting, the spark
plug cap must be removed from the
spark plug when assembling, checking
and/or maintenance is done.
To do a run-in
• During the first 10 hours of operation, do not apply
full throttle without load for extended periods.

To use the product

• Hold the product as close to your body as possible to
get the best balance. Use the harness to support the
weight of the machine and make it easier to handle.
• Make sure that the tip does not touch the ground.
• Do not rush the work, but work steadily until all the
branches have been cut back cleanly.
15