Mettler Toledo ICS241 Instrucciones De Manejo página 22

22
Application
•
If tolerance default values have been set in the menu, only the target has to be
specified with tolerance types Relative and Percent.
•
The upper tolerance value has to be greater than or equal to the lower one (High ≥ Low)
or, respectively, the target weight has to be greater than or equal the lower tolerance
value and smaller than or equal the upper tolerance (Tol + ≥ Target ≥ Tol –).
3.4.3 Specifying target number of pieces
Prerequisite
9 At least one of the
Determining the piece weight
➜ Proceed as described in section 3.1.1 or section 3.1.2, page 14.
•
For alternate procedures to determine the piece weight refer to the counting section,
see section 3.1, page 14.
•
If you use the unit PCS, the tolerance type percent is not available.
Weighing in the target number of pieces
➜ Proceed as described in section section 3.4.2, page 21.
The display unit is PCS.
or counting soft keys is activated.
ICS241 30232251A