Automatic Re-Ignition; Important; Flame Description; Power Failure - Thermador Professional PRO-HARMONY PRG30 Manual De Uso Y Cuidado

Automatic Re-Ignition

If any one or more burners blow out, the electronic igniter
automatically activates to re-light the flame. Do not touch
the burners when the igniters are active.

Important:

• For proper combustion do not use the cooktop without
the burner grates in place.
• There is a slight sound associated with gas combustion
and ignition. This is a normal condition.
• On cooktops using propane gas (LP), a slight "pop"
sound may be heard at the burner ports a few seconds
after the burner has been turned off.

Power Failure

I
• n the event of a power failure, only the standard
burners can be manually lit. It is necessary to light each
one individually.
• If the cooktop is being used when the power failure
occurs, turn all knobs to the OFF position.
• The standard burners can be lit by holding a match at
the ports and turning the control knob to the
position. Wait until the flame is burning all around the
burner cap before adjusting the flame to the desired
height.
• The ExtraLow burners cannot be used during a power
failure. Be sure to turn them off.
• If an ExtraLow burner is on when a power failure
occurs, it cannot be turned back on until the knob is
first turned off.
• The griddle cannot be used during a power failure.
• If you smell gas, refer to safety precautions listed
inside the front cover.
WARNING:
In the event of a power failure, all knobs are to
be turned to the OFF Position. Only the
standard burners can be lit manually.

Flame Height

• The correct flame height depends on 1) size and
material of pan being used; 2) food being cooked; and
3) amount of liquid in the pan.
• Never extend the flame beyond the base of the pan.
• Use a low or medium flame for pan materials that
conduct the heat slowly, such as porcelain coated steel
or glass-ceramic.
English 14

Flame Description

• The burner flame color should be blue with no yellow
on the tips. It is not uncommon to see orange in the
flame color; this indicates the burning of airborne
impurities in the gas and will disappear with use.
• With propane (LP) gas, slight yellow tips on the primary
cone are normal.
• The flame should burn completely around the burner
cap. If it doesn't, check that the cap is positioned
correctly on the base and that the ports are not
blocked.
• The flame should be stable with no excessive noise or
fluttering.
WARNING:
This product contains or, through ordinary use
for its intended purpose, facilitates emission of
chemicals or other substances known to the
State of California to cause cancer and/or birth
defects or other reproductive harm. To minimize
exposure to these chemicals:
1.The burners should be adjusted by a certified
installer or agency to ensure proper
combustion.
2.Ensure proper ventilation with an open
window or use a ventilation fan or hood when
cooking with Gas.
3.Always operate the unit according to the
instructions in this manual.
Dark Blue
S e c o n d a r y
Cone
Light Blue
Primary
Cone
Figure 16: Flame Color