Mounting Backrest Frame; Adjusting The Seat Height And Seat Angle - Vermeiren Inovys II-F Manual De Instrucciones

3.3

Mounting backrest frame

L
Risk of injury - Make sure that the ring of safety pin Ⓐ is firmly
WARNING:
secured.
3.4

Adjusting the seat height and seat angle

L
WARNING:
Risk of injury - Make sure that all screws are properly tightened with
the appropriate tool.
L
WARNING:
Risk of injury - Self-locking nuts are only to be used once or are to be
secured with an additional screw locking device.
L
WARNING:
Risk of injury - Adjust the brakes if necessary after adjusting the seat
height and seat angle.
L
WARNING:
Risk of injury - Check that the seat heights are mounted in the same
position on both sides.
L
WARNING:
Risk of tipping over - When the driving wheels are adjusted, the
position of the wheels are altered.
The seat height of the Inovys II-F multi-position wheelchair is adjustable in 3 positions in
steps of 35 mm. The seat height can be adjusted by moving the seat frame in different
positions in the front tube Ⓐ and rear wheel plate Ⓒ, and the gas spring in the attachment
plate Ⓑ. These components you can find below the seat frame.
After you have taken the wheelchair out of the
original packaging, push the backrest frame to the
back into the 90° position. Guide the safety pins Ⓐ
into the appropriate socket to attach the spring Ⓑ,
which is located at the back under the seat.
Check that no cables are squeezed.
Part Ⓐ, Ⓑ, Ⓒ
Seat height
390 mm Hole 1
425 mm Hole 2
460 mm Hole 3
Table 2: Seat heights
Page 16
Inovys II-F
2016-05