Tools; Manner Of Delivery; Mounting Backrest; Adjusting The Seat Height And Seat Angle - Vermeiren Inovys II Manual De Instrucciones

3.1

Tools

To set up the wheelchair the following tools are needed.
Wrench set n° 10 to n° 22
•
Allen key set n° 3 to n° 8
•
Screwdriver Phillips head
•
Screwdriver
•
Nipper
•
Pliers
•
Assembly and settings may only be performed by a specialist dealer.
3.2

Manner of delivery

The Vermeiren Inovys II shall be delivered with:
1 frame with arm supports, rear and front wheels
•
1 pair footrests
•
Seat and back cushions
•
Tools
•
Manual
•
Accessories (optional)
•
When you receive the wheelchair, please check that the product supplied is complete and
fully functional. Warranty claims are only valid if the manufacturer (supplier) is notified in
writing within a period of two weeks. In the case of any defect that is not immediately
evident, warranty claims are only valid if the manufacturer (supplier) is notified in writing
within two weeks after it is detected. We shall remedy defects in the manner of our choosing
- either by carrying out a repair or by providing a replacement.
3.3

Mounting backrest

WARNING:
Risk of injury - Make sure that the ring of safety pin
   
secured.
3.4

Adjusting the seat height and seat angle

WARNING:
Risk of injury - Make sure that all screws are properly tightened with
   
the appropriate tool.
WARNING:
Risk of injury - Self-locking nuts are only to be used once or are to be
   
secured with an additional screw locking device.
WARNING:
Risk of injury - Adjust the brakes if necessary after adjusting the seat
   
height and seat angle.
After you have taken the wheelchair out of the
original packaging, push the backrest to the back
into the 90° position. Guide the safety pins
the appropriate socket to attach the spring
which is located at the back under the seat.
Check that no cables are squashed.
ƒ‰‡
Inovys II
2011-11
is firmly
into
,