To Examine The Wheels; To Replace The Hydraulic Oil; To Do A Check Of The Hydraulic Oil Level - Husqvarna FS5000 D Manual Del Usuario

4. Tighten the 2 bolts (A).
5. Loosen the bolts for the belt tension
counterclockwise approximately 1/16 of a turn.
1 /
16
CAUTION: Make sure that the 4 V-belts
have the same tension. Do not adjust the
tension of the V-belts too much.

To examine the wheels

• Examine the wheels for wear or damage. Replace
wheels and hubs if they are damaged or worn out.
• Examine if the rear wheel hubs and wheels are
loose. Tighten loose screws and nuts.

To do a check of the hydraulic oil level

1. Remove the plug in the inspection opening on the
hydraulic reservoir. Refer to
side on page 4 for the hydraulic reservoir position.
2. Make sure that the oil level is at the bottom edge of
the opening on the hydraulic reservoir.
1143 - 002 - 08.07.2019
1 /
16
Product overview, right
3. If it is necessary, remove the hydraulic reservoir cap
and fill the hydraulic reservoir until the oil level is
Product overview, right side on
correct. Refer to
page 4 for the correct type of oil.
CAUTION: Do not fill too much. Oil can
come out of the inspection opening.
4. Install the hydraulic reservoir cap.
5. Install the plug in the inspection opening on the
hydraulic reservoir.

To replace the hydraulic oil

1. Remove the plug from the inspection opening on the
hydraulic reservoir.
2. Use a manual oil pump to drain the oil through the
inspection opening on the hydraulic reservoir.
3. Replace the hydraulic system filter. Refer to
replace the hydraulic system filter on page 32 .
To
33