Basic Working Techniques; To Do Before You Start The Product; To Decrease Dust During Operation - Husqvarna K 7000 Manual Del Usuario

WARNING: Be careful when you put the
blade in an existing cut.
WARNING: Make sure that the work piece
cannot move during a cutting operation.
WARNING: Only you and proper working
technique can eliminate kickback and its
dangers.
• Always support the work of piece so that the cut can
keep open when cutting through. When the cut is
open there is no kickback. If the cut is closed and
pinches the blade, there is a risk of kickback.

To do before you start the product

• Read the operator's manual carefully and make sure
that you understand the instructions.
• Do the daily maintenance. Refer to
schedule on page 22 .
• Make sure that the power pack is connected to a
grounded power outlet.
• Make sure that the mains voltage agrees with the
specification on the rating plate on the product.
• Make sure that only approved persons are in the
work area.
• Make sure that you are in a safe and stable position
during operation.
• Always use a power pack with RCD. Refer to the
operator's manual for the power pack.
• Make sure that the water connector is connected
with a water supply. Refer to
supply on page 20 .

To decrease dust during operation

The product has a wet cutting kit to decrease harmful
dust in the air during operation. The wet cutting kit has
low water consumption.
• When possible, use wet cutting blades with water
Diamond blades for wet cutting on
cooling. Refer to
page 12 .
• Adjust the water flow with the valve. The correct flow
is different for different types of tasks.
18
Maintenance
To connect the water
• Make sure that the water pressure is correct. Refer
Technical data on page 25 . If the water hose
to
comes off at the supply source, the supplied water
pressure can be too high.

Basic working techniques

WARNING: Do not pull the product to one
side. This can prevent the free movement of
the cutting blade. The cutting blade can
break and cause injury to the operator or
bystanders.
WARNING: Do not grind with the side of the
cutting blade. The cutting blade can break
and cause injury to the operator or
bystanders. Only use the cutting edge.
WARNING: Make sure that the cutting blade
is installed correctly and does not show
signs of damage.
WARNING: Before cutting in an existing cut
made by a different blade, make a sure that
the slot is not thinner than your blade as that
can result in binding in the cutting slot and a
kickback.
WARNING: Cutting metal generates sparks
that can cause fire. Do not use the product
near flammable material or gases.
• The product is made to cut with diamond blades
made for high speed handheld product. The product
must not be used with other types of blade, or for
other types of operation.
• Do a check that the correct cutting blade is used for
the material to be cut. Refer to page 11 for instructions.
• Do not cut asbestos materials.
• Keep a safe distance from the cutting blade when
the motor is on. Do not try to stop a rotating blade
with a part of your body. To touch a rotating blade,
although the motor is off, can result in serious injury
or death.
• Make sure that only approved persons are in the
work area.
• The cutting blade continues to rotate for a while after
the power trigger is released. Make sure that the
cutting blade has stopped before the product is
moved or put down. If it is necessary to stop the
cutting blade quickly, let the cutting blade lightly
touch a hard surface.
• Do not move the product with the motor on.
• Hold the product with 2 hands. Hold the product
tightly with thumbs and fingers fully around the
plastic handles with insulation. The right hand must
be on the rear handle and the left hand on the front
Cutting blades on
1448 - 003 - 13.02.2020