Idiomas disponibles
Idiomas disponibles
children. There is a risk of suffocation!
Repairs or/and maintenance work must only be carried out by
„
qualified electricians.
Only use the welding cables provided in the scope of delivery.
„
During operation, the device should not be positioned directly on
„
the wall, should not be covered or jammed between other devices
so that sufficient air can always be absorbed through the ventila-
tion slats. Make sure that the device is correctly connected to the
mains voltage. Avoid any form of tensile stress of the power cable.
Disconnect the plug from the socket prior to setting up the device in
another location.
If the device is not in operation, always switch it off by pressing
„
the ON/OFF switch. Place the electrode holder on an insulated
surface and only remove the electrodes from the holder after
allowing it to cool down for 15 minutes.
Pay attention to the condition of the welding cable, electrode
„
holder and the earth terminal. Wear and tear of the insulation and
the live parts can lead to hazards and reduce the quality of the
welding work.
Arc welding creates sparks, molten metal parts and smoke.
„
Therefore ensure that: All flammable substances and/or materials
are removed from the workplace and its immediate surrounding.
Ensure the workplace is ventilated.
„
Do not weld on containers, vessels or tubes that contain or
„
contained flammable liquids or gases.
„
welding current circuit. The no-load voltage between the electrode
holder and earth terminal can be dangerous, there is a risk of
electric shock.
Do not store or use the device in a damp or wet environment or in
„
the rain. Protection rating IP21S is applicable in this case.
Protect your eyes using the appropriate protective glasses
„
(DIN level 9–10), which are fastened to the supplied welding
mask. Wear gloves and dry protective clothing that are free of oil
and grease to protect the skin from exposure to ultraviolet radiation
of the arc.
„
pipes.
Please note:
The light radiation emitted by the arc can damage eyes and cause
„
8
GB/IE/NI/CY/MT
Avoid any form of direct contact with the
Do not use the welding power source to defrost
