Idiomas disponibles
Idiomas disponibles
welding cables should be completely unwound and installed
–
parallel on the floor, if possible
if possible, devices and systems at risk from interference
–
radiation should be removed from the work area or shielded.
z Before using the device
Take the device and accessories out of the packaging and check them for damage (e.g. transport damage).
Fix the carrying strap
„
Connect the electrode holder
„
Position an electrode in the clamps of the electrode holder.
„
z Fit welding mask
Fit the handle
onto the welding mask
„
8
Fit the protective glass
„
The protective glass
„
NOTE: If you are not able to push the protective glass
protective glass
.
11
z Using the device
NOTE: The welder is designed for welding with electrodes.
Use the electrode holder clamps without protruding bracket screws, which meet the current safety
„
standards.
Make sure that the ON/OFF switch
„
not plugged into the socket.
Connect the welding cable according to its polarity and in accordance with the specifications of the
„
electrode manufacturer.
To do this, connect the connector of the earth terminal
„
welder (marked with "-").
Connect the connector of the electrode holder
„
(marked with "+").
Put on appropriate protective clothing in accordance with the specifications and prepare your
„
workplace.
Connect the earth terminal
„
Clamp the electrode into the electrode holder
„
Switch the device on by setting the ON/OFF switch
„
Adjust the welding current using the rotary knob
„
NOTE: See the following table for information on the recommended welding current to be used,
depending on the electrode diameter.
Ø Electrode
1.6 mm
2.0 mm
2.5 mm
onto the device (see Fig. C1 – C4).
1
and the earth terminal
5
7
onto the welding mask
11
must be pushed in from the top.
11
is set to position "O" ("OFF") or that the mains cable
9
to the workpiece.
4
Welding current
40–60 A
60–80 A
80–100 A
to the welding device.
4
, as shown in Fig. A.
, as shown in Fig. B.
7
in fully, gently press on the outside of the
11
with the relevant output on the inverter
4
with the relevant output on the inverter welder
5
.
5
to the "I" ("ON") position.
9
depending on the electrode being used.
3
GB/IE/NI/CY/MT
is
10
15
