Idiomas disponibles
Idiomas disponibles
Section
Initial Settings
04
Adjusting initial settings
1
Press SRC and hold until the unit turns
off.
2
Press MULTI-CONTROL and hold until
CLOCK SET appears in the display.
3
Turn MULTI-CONTROL to select one of
the initial settings.
CLOCK SET (clock)—FM STEP (FM tuning
step)—AM STEP (AM tuning step)—
WARNING TONE (warning tone)—AUX1 (aux-
iliary input 1)—AUX2 (auxiliary input 2)—
DIMMER (dimmer)—SW CONTROL (rear out-
put and subwoofer controller)—DEMO MODE
(feature demo)—EVER SCROLL (ever scroll)—
BT AUDIO (Bluetooth audio)—
PIN CODE INPUT (pin code input)—
BT VER INFO (Bluetooth version information)
# You can also perform the same operations by
pushing MULTI-CONTROL up or down.
# You can also select the function by pressing
FUNCTION on the remote control.
# To cancel initial settings, press BAND/ESC.
# BT AUDIO, PIN CODE INPUT and
BT VER INFO can be selected only when Blue-
tooth adapter (e.g., CD-BTB100) is connected to
this unit.
Setting the clock
Use these instructions to set the clock.
1
Use MULTI-CONTROL to select
CLOCK SET.
2
Press MULTI-CONTROL to display the
setting mode.
# Press BACK to return to the previous display.
3
Press MULTI-CONTROL to select the seg-
ment of the clock display you wish to set.
Each time you press MULTI-CONTROL, one
segment of the clock display is selected.
Hour—Minute
As you select segments of the clock display,
the selected segment blinks.
26
En
All manuals and user guides at all-guides.com
4
Turn MULTI-CONTROL to put a clock
right.
# You can also perform the same operations by
pushing MULTI-CONTROL up or down.
Setting the FM tuning step
The FM tuning step employed by seek tuning
can be switched between 100 kHz, the preset
step, and 50 kHz.
! If seek tuning is performed in 50 kHz steps,
stations may be tuned in imprecisely. Tune
in the stations with manual tuning or use
seek tuning again.
1
Use MULTI-CONTROL to select FM STEP.
2
Press MULTI-CONTROL to display the
setting mode.
3
Turn MULTI-CONTROL to select the FM
tuning step.
Turning MULTI-CONTROL will switch the FM
tuning step between 50 kHz and 100 kHz. The
selected FM tuning step will appear in the dis-
play.
# You can also perform the same operations by
pushing MULTI-CONTROL up or down.
Note
The tuning step remains at 50 kHz during manual
tuning.
Setting the AM tuning step
The AM tuning step can be switched between
9 kHz, the preset step, and 10 kHz. When
using the tuner in North, Central or South
America, reset the tuning step from 9 kHz (531
kHz to 1 602 kHz allowable) to 10 kHz (530 kHz
to 1 640 kHz allowable).
1
Use MULTI-CONTROL to select
AM STEP.
