Husqvarna 520iLX Manual Del Usuario página 10

2. Push the power trigger lockout forward (A) and
down. Hold the power trigger lockout against the
handle (B) and make sure that it returns to its
original position when you release it.
3. Make sure that the power trigger and the power
trigger lockout moves freely and that the return
springs operate properly.
4. Start the product, refer to
page 13 .
5. Push the power trigger fully to apply full speed.
6. Release the power trigger and make sure that the
cutting attachment stops and remains still.
To do a check of the cutting attachment guard
WARNING:
attachment without an approved and
correctly attached cutting attachment guard.
Always use the recommended cutting
attachment guard for the cutting attachment
that you use, see
If an incorrect or faulty cutting attachment
guard is attached this can cause serious
personal injury.
The cutting attachment guard stops objects that ejects in
the direction of the operator. It also prevents injuries that
occur if you touch the cutting attachment.
1. Stop the motor.
10
B
A
To start the product on
Do not use a cutting
Accessories on page 19 .
2. Do a visual check for damages, for example cracks.
3. Replace the cutting attachment guard if it is
damaged.
Cutting attachment
WARNING:
make sure the cutting attachment stops
completely before you work on any part of
the cutting attachment.
WARNING:
attachment with the guards we recommend,
Accessories on page 19 .
see
Trimmer head
• Always use the correct trimmer head, cutting
attachments and always use the recommended
trimmer line. Refer to
the assembly in the end of the Manual.
• Make sure that the cutter on the trimmer guard is not
damaged.
• Make sure that the trimmer line is wound tightly
and equally around the drum to prevent unusual
vibrations from the product. Different cord lengths
can result in vibrations that are not necessary. Tap
the trimmer head to get correct length on the cord.
To increase the life of the cord it can be soaked in water
for 2 days or more before assembly. This will make the
cord more resistant.
Safety instructions for assembly
WARNING:
manual together with approved accessory
manual.
• Remove the battery from the product before you
assemble the product.
• Use the approved protective gloves.
• A damaged or incorrect guard can cause injury. Do
not use a cutting attachment that does not have an
approved guard attached.
• Make sure that you assemble the cover and shaft
correctly before you start the product.
• If a harness is supplied with the attachment, the
harness must be correctly attached to the product.
The harness makes operation safe and prevents
injury to the operator or other persons.
Remove the battery and
Only use the cutting
Accessories on page 19 and
Read this power unit
756 - 012 - 15.02.2024