Inserting The Melitta Claris Water Fi Lter - melitta CAFFEO SOLO & milk Manual De Instrucciones

6 Inserting the Melitta
A Melitta Claris water fi lter is supplied with the appliance for fi ltering out limescale
® ®
and other contaminants. Please only insert it after starting up the appliance
for the fi rst time. If you use the fi lter, you will have to descale the appliance less
frequently and the water hardness will automatically be set to hardness level 1
(see page 62). The service life of your appliance will be extended thanks to this
reliable protection from limescale. The water fi lter should be changed regularly
(every 2 months); at the latest, however, it must be changed when the symbol for
the water fi lter is shown on the display.
Prerequisite: The appliance must be switched off (see „Switching on and off"
on page 54).
• Simultaneously press the button for coffee strength
OFF button
→ The symbol for the water fi lter
procedure. The symbol for the drip tray
• Empty the drip tray and then reinsert it.
→ The symbol for the water tank
• Put the water fi lter in a glass with fresh tap water for several minutes
before you insert it.
• Flip up the lid of the water tank (Fig. A, no. 7) and pull the water tank up
and out of the appliance.
• Empty the water tank.
• Screw the Melitta
bottom of the water tank.
• Fill the water tank to the maximum mark with fresh tap water and
reinsert it.
→ The valve symbol
• Place a suffi ciently large vessel (e.g. the coffee grounds container)
under the steam pipe.
for more than 2 seconds.
fl ashes during the entire change
illuminates.
Claris water fi lter carfully into the thread on the
® ®
illuminates.
Claris water fi lter
® ®
is illuminated.
and the ON /
55