Bluewater SPIRIT Manual Del Propietário página 15

Symptom
7a The ON light and the
FILTER light are Flashing
quickly.
7b The water purifier makes
noise, or the FILTER light
is Flashing quickly while
the ON light is On. This
is due to low inlet water
pressure.
8 The ON light is Flashing
slowly. The FILTER light
and SERVICE light are
On.
9 The FILTER light and
the SERVICE light are
Flashing quickly.
The flow rate from the
purified water faucet is
low.
Water does not flow
from the purified water
faucet.
The water from the
water purifier smells
bad.
Cause
The inlet water low pressure
restart function is active.
The Inlet Grid Filter is blocked.
The prefilter is blocked.
The inlet pressure was lower than
1.5 bar (22 psi) during operation.
The faucet is not completely
closed.
There is a small leakage inside or
outside the water purifier.
The leakage overflow protection
system is activated.
The water purifier needs to be
descaled.
The purified water tubing has
been sharply bent or blocked.
The inlet water shut-off valve is
closed.
Possible Microbial (bacterial)
growth in the water purifier due
to the water purifier not being
used for a long period of time.
15
Solution
See Complete User manual.
See Complete User manual.
See Complete User manual.
If the water purifier stops,
contact your Bluewater dealer.
Close the faucet.
See Complete User manual.
Disconnect the water purifier
from power and clean the
base plate. If the overflow
protection is activated again,
contact your Bluewater dealer.
See Complete User manual.
Make sure that there are no
sharp bends in the purified
water tubing and that it can
move freely.
Open the inlet water shut-off
valve.
Spirit may need to be
disinfected. See Complete User
manual.
© Bluewater Group 2022
EN