Stihl BR 350 Manual De Instrucciones página 25

Carefully remove the rope rotor with
N
washer (4) and pawls (5).
Use a screwdriver to pry the rope
N
out of the starter grip.
Remove the remaining rope from
N
the rotor and starter grip.
Thread the new rope through the
N
starter grip and tie one of the special
knots shown.
Pull the knot back into the grip.
N
BR 350, BR 430
Thread the end of the rope through
N
the top of the guide bushing (6) and
rope rotor (7) and secure it with a
simple overhand knot.
Coat the rope rotor bearing bore
N
with non-resinous oil.
Slip the rotor over the starter
N
post (8) – turn it back and forth to
engage the anchor loop of the
rewind spring.
Refit the pawls (5) in the rotor.
N
Fit the washer (4) on the starter
N
post.
Use a screwdriver or suitable pliers
N
to install the spring clip (3) on starter
post and engage it on the pawls'
peg – the spring clip must point
counterclockwise as shown in the
illustration.
Tensioning the rewind spring
Make a loop in the unwound starter
N
rope and use it to turn the rope rotor
six full revolutions in the direction of
the arrow.
Hold the rotor steady.
N
Pull out and straighten the twisted
N
rope.
English
23