Ferroli EGEA TECH 90 LT Manual De Uso, Instalación Y Mantenimiento página 145

EGEA TECH
4.2 UNPACKING
The packaging material (staples,
boxes, etc.) must not left with-
in the reach of children as they
ATTENTION
pose a risk to them.
Unpacking must done carefully in order not to damage the de-
vice casing if using knives or cutters to open the cardboard
packaging.
After removing the packaging, check the integrity of the unit. In
case of doubt, do not use the device and contact an authorised
technician.
Before eliminating the packaging in accordance with current
environmental protection laws, make sure that all the accesso-
ries supplied have been removed from it.
RECYCLING / DISPOSAL.
All packaging materials must be
disposed of in accordance with
the laws in force in the country
of use.
4.3 RECEIPT
In addition to the units, the packages contain accessories and
technical documentation for use and installation.
• Check that the following are present:
- User, Installation and Maintenance Manual
- Safety valve
- 6-core cable digital inputs
For the entire period in which the device remains inactive,
pending commissioning, it is advisable to place it in a place
protected from atmospheric agents and the environmental con-
ditions indicated in paragraph "6.1 STORAGE" on page 149.
90 LT - 120 LT
cod. 3540000400 - Rev. 03 - 09/2023
5. CONSTRUCTION
CHARACTERISTICS
5.1 COMPONENT IDENTIFICATION
REF. DESCRIPTION (fig. 40 - fig. 41 - fig. 42)
1 Heat pump
2 User interface
3 Steel casing
4 Electrical heater
5
Magnesium anode
6 Ventilation air outlet (Ø 125 mm)
7 Ventilation air inlet (Ø 125 mm)
8
Cold water inlet connection
9 Hot water outlet connection
11 Condensate drain (patuzzi)
14 Enamelled steel tank
15
Capacitor
16 Rotary compressor
17 Finned coil (evaporator)
18
Fan
19 Water tank probes
21 Polyurethane insulation
23
Tube for safety thermostat bulb
24 Electronic board
25 Wi-Fi card
Cover for accessing heating element, safety thermostat bulb,
26
boiler probes and power board
2
9
24
8
11
26
fig. 40
EN
145