Idiomas disponibles
Idiomas disponibles
Using the TORSIOTRONIC®
CAUTION
Risk of injury due to overloading the
TORSIOTRONIC
End the tightening procedure when
the set torque has been reached.
ATTENTION!
Damage to the TORSIOTRONIC
possible on overloading.
Make sure that the
TORSIOTRONIC
Do not drop the TORSIOTRONIC
Do not expose the TORSIOTRONIC
to any jolts.
Actuate the TORSIOTRONIC
only. When tightening, hold the TORSIOTRONIC
on an axis with the screw.
Working in "Click" function mode
Tighten evenly and, in the final phase, without
interruption until a clear jolt is felt and a click is
heard.
The set target torque is reached.
34
.
®
®
is not overloaded.
®
.
®
®
via the handle
®
®
After clicking, the TORSIOTRONIC
ready for use again.
During the fastening process in "Click" function
mode, the following displays and signals are
provided depending on the settings that have been
carried out:
The current torque value is displayed.
If an alert limit has been set in the
CONFIGURATION menu, the current value is
shown in yellow as of reaching the alert limit. The
signal lamps light up yellow.
If a tolerance range has been set and this has
been reached, the current value is shown in
green. The signal lamps light up green. A short
audible signal is heard.
When the previously set target torque has been
reached, the TORSIOTRONIC
perceptible jolt and an audible click.
If the previously set upper target torque tolerance
range is exceeded, the current value is shown in
red. The signal lamps light up red. A long audible
signal is heard.
is immediately
®
triggers with a
®
