Cameo PIXBAR G2 Manual De Usuario página 19

extensive programming. Connect the slave and master units (same model, same software version)
using a DMX cable or via W-DMX
Assign the fixtures to one of up to 24 groups (plus Group 0) according to preference, whereby se-
veral lights can be assigned to one group. The group number is also the factor by which the delay
time set in the master unit is multiplied.
Setup example:
SYSTEM SETTINGS (Settings)
Starting from the main screen, press MENU to enter the main menu. Using the UP and DOWN
buttons, select Settings and confirm with ENTER.
This will take you to the submenu for editing the following submenu items (see table, select with
UP and DOWN, confirm with ENTER, change value or status with UP and DOWN, confirm with
ENTER).
Wireless
=
settings
.
™
0 - 24 Set slave group for signal delay
XLR (permanently active)
Activate W-DMX module
Deactivate W-DMX module
Disconnect all connections
and place in pairing standby
mode
W-DMX activated
W-DMX deactivated
W-DMX mode: Receiver
G3 (G3 transmission standard)
G4s (G4s transmission standard)
Unpair all devices and make them ready
for pairing
19