Cameo PIXBAR G2 Manual De Usuario página 18

EDIT LOOP
The brightness, step duration and fade time can be set independently for all eight loops. Starting
from the main screen, press MENU to enter the main menu. Using UP and DOWN, select Stand
Alone, confirm with ENTER, then select Edit Loop and confirm again. Now select the desired loop
for editing and confirm.
This will take you to the submenu for configuring the submenu items (see table). The settings for
each loop are made independently and are retained even after restarting the device.
SLAVE MODE
Standard slave mode: Starting from the main screen, press MENU to enter the main menu.
Using the UP and DOWN buttons, select Slave, confirm with ENTER, then select Slave Group 0
and confirm again. Connect the slave and master units (same model, same software version)
using a DMX cable or via W-DMX™ and activate one of the stand-alone modes (Direct LED, CCT,
Play Loop) in the master unit. The slave unit will now follow the master unit.
Extended slave mode: If you wish to control the slave units in master/slave mode using one
of the Auto Program or Play Loop stand-alone modes, the control signal can be played back
with a time delay of up to 24 steps. The delay is set in the Stand Alone menu Master/Alone
in the master unit; the delay factor is set in the slave menu of the corresponding fixture (Group).
This is a simple way to create a running light effect with a large number of identical lighs that are
running the same software version, which would otherwise require a suitable DMX controller and
18
Step selection
Set the step duration for the selected
step
Set the fade time for the selected
step
Selection of the colour temperature or
blackout for the selected step
Select colour temperature or blackout
or skip selected step