Cameo PIXBAR G2 Manual De Usuario página 17

Starting from the main screen, press MENU to enter the main menu. Use UP and DOWN to select
Stand Alone, confirm the selection, then select CCT and confirm again with ENTER. Now select
the menu item you want to edit, confirm the selection and make the settings as desired. Confirm
each entry.
PLAY LOOP STAND-ALONE MODE (8-step colour sequences 1 - 8)
The 8 available loops are pre-programmed at the factory, but can be customised in the Edit Loop
menu. The brightness can be set at a higher level.
Starting from the main screen, press MENU to enter the main menu. Using UP and DOWN, select
Stand Alone, confirm with ENTER, then select Play Loop and confirm again with ENTER. Now
select the menu item you want to edit, confirm the selection and make the settings as desired.
Confirm each entry.
TIMER FUNCTION
The timer function allows the Static stand-alone mode to be timer-controlled; the fade-in time can
be set from 0 to 60 minutes, the dwell time from 1 to 24 hours and the fade-out time from 0 to
60 minutes. After activation of the timer function, the timer control will take effect upon the next
start-up of the system.
Starting from the main screen, press MENU to enter the main menu. Select Stand Alone, confirm
the selection, then select Timer and confirm again. Under Timer, select the setting On and con-
firm. For custom timer settings, select Fade In, Dwell Time or Fade Out and confirm. You can
now adjust the respective value as desired. Confirm all entries. To deactivate the timer function,
select Timer->Off and confirm the entry.
Note: The timer function can be used in master/slave mode via cable and W-DMX .
™
17