Cameo PIXBAR G2 Manual De Usuario página 16

In the stand-alone modes Auto Program and Play Loop, you can set a delay for slave units to delay
the output of the control signal.
Starting from the main screen, press MENU to enter the main menu. Now select Stand Alone,
confirm, select Master/Alone and confirm again.
This will take you to the submenu for configuring the submenu items (see table).
DIRECT LED STAND-ALONE MODE
The stand-alone mode "Direct LED" allows you to set the dimmer, amber, warm white and cold
white directly on the device, similar to a DMX control unit. This allows you to create a custom
scene without an additional DMX controller.
Starting from the main screen, press MENU to enter the main menu. Use UP and DOWN to select
Stand Alone, confirm with ENTER, then select Direct LED and confirm again with ENTER. Now
select the menu item you want to edit, confirm the selection, set the desired value and confirm
the entry.
CCT STAND-ALONE MODE (Correlated Colour Temperature)
The stand-alone mode "CCT" allows you to adjust the colour temperature in 100K increments
from 1800K to 6500K, as well as the hue (tint) and brightness (dimmer).
16
Control signal is forwarded via DMX OUT
Activate DMX control signal forwarding via W-DMX
Deactivate DMX control signal forwarding via W-DMX
Pair with ready-to-pair W-DMX devices
Disconnect all W-DMX connections
Set DMX delay for slave units: Off, 0.1s - 2.0s
Do not forward control signal