Cameo PIXBAR G2 Manual De Usuario página 14

OPERATION
NOTES
• As soon as the fixture is correctly connected to the power supply, the following messages are
displayed in succession: "Update wait ..." (for service purposes only), "Welcome to Cameo", the
model name and the software version. After this process, the light is ready for operation and
the previously activated operating mode is launched.
• If there is no input for approx. 30 seconds, the display automatically returns to the main screen.
• Note on the main screen in operating modes with external control: In the event that the control
signal is interrupted, the characters in the display begin flashing; once the control signal is
present again, the flashing stops.
• Briefly pressing UP from the main screen rotates the display by 180°.
SET DMX START ADDRESS (DMX address)
Starting from the main screen, press MENU to enter the main menu. Now use UP and DOWN to
select DMX Address and confirm with ENTER. Using the UP and DOWN buttons, configure the
desired DMX start address and press ENTER to confirm (the highest possible value depends on
the selected DMX mode).
CONFIGURE DMX MODE (DMX Mode)
Starting from the main screen, press MENU to enter the main menu. Now use UP and DOWN to
select DMX Mode and confirm with ENTER. Now select the desired DMX mode using UP and
DOWN and confirm the selection with ENTER. DMX modes with DMX delay channel and group
selection (Group 0 - 24) are marked with "D". DMX tables with the channel assignments can be
found in the DMX CONTROL section of this user manual.
14