Dräger X-plore 8000 Instrucciones De Uso página 18

en |
Description
Illustration of the control panel on the fold-out page (figure D)
1 Rechargeable battery status indicator
2 Particle filter residual capacity indicator
3 On/off button
4 Flow rate indicator
5 Reduce flow rate
6 Increase flow rate
Display on control panel
Indicator
Segments light up in green.
Segments light up in green.
Segments light up in green.
Segments blink yellow or red. Malfunction (see
1) The residual capacity of the gas filter or the gas filter components of
the combination filter cannot be indicated.
Acoustic signals
Signal 1x
tone short
Frequency low
General
acoustic feed-
back
The or
button is x
pressed
The device
is switched
on with
The device
is switched
off with
18
Meaning
Battery capacity depending
on number of displayed seg-
ments:
> 75 % (4 segments)
> 50 % (3 segments)
> 25 % (2 segments)
< 25 % (1 segment)
Residual particle filter capac-
1)
ity depending on number of
displayed segments:
> 75 % (4 segments)
> 50 % (3 segments)
> 25 % (2 segments)
< 25 % (1 segment)
Flow rate intensity depending
on number of displayed seg-
ments:
high flow rate (3 segments)
medium flow rate (2 seg-
ments)
low flow rate (1 segment)
chapter 5 Troubleshooting)
Tone Tone Tone
seque seque seque
nce 3x nce 4x nce
2x/min
ute
low - 3x low
mediu mediu
m - m -
high 1x low
x
x
Signal
tone
Frequency
Warnings
Filter or
recharge-
able battery
Malfunc-
tion during
switch-on
Alarms
Filter,
recharge-
able bat-
tery, other
faults
For further information on acoustic signals in case of warnings
and alarms, see chapter 5 Troubleshooting.
Warning devices
The blower unit displays malfunctions with segments flashing
red or yellow on the control panel. The blower unit will also
trigger an acoustic and vibration alarm.
Depending on the thickness and material of the clothing,
the vibration alarm might not be perceived.
3.2.2 Filter and facepieces
Filter and facepieces are described in separate Instructions
for Use.
Half masks/full face masks and hood/helmet/protective visor
have different flow ranges. The blower unit automatically
detect the respiration connection type and automatically
selects the appropriate flow range.
Tone
seque
3.2.3 Breathing hoses
nce
recur-
The following breathing hoses are available:
ring
– standard hose
high
– flexible hose for increased comfort
Both breathing hoses are available for each of the following
facepiece types:
– Plug-in connector (for hoods, helmet/hood combinations,
bump cap/hood combination, helmets with visors)
– Bayonet-type connector (for helmets and protective
visors)
– Round-thread connector (for half masks and full face
masks)
CAUTION
Observe the device combination and protection class!
► If half masks are used, the flexible hose must be used to
achieve device classification TM2.
1x Tone Tone
short seque seque
nce 3x nce 4x
low low - 3x
mediu mediu
m - m -
high 1x low
Instructions for use | Dräger X-plore
Tone Tone
seque seque
nce nce
2x/min recur-
ute ring
low high
x
x
x
®
8000