Genie Directlift 2060 Manual De Funcionamiento Y Mantenimiento página 6

2060-3060 eng.qxd 11/9/05 11:02 AM Page 6
Measure garage door height (7'-6", 8'-0", or taller) with
tape measure.
A If door height is 7'-6" or less, continue with Check Step 4.
B If door height is 8'-0", you need a Rail Extension
Kit. (Figure 3) (See Accessories Order Form, page 19).
C If door height is taller than 8'-O",you will require a different rail.
Contact an Genie Customer Service Representative at 1-800-
35-GENIE.
CH_iG DOO_ M_it%[;@H: {/_:E_
Figure 3 Rail Extension Kit
Rail Extension for
8' door
........ \ii7 .......
NOTE
The header is a heavily reinforced section of the wall just
above the top of the garage door opening.
A
B
Find vertical center line of door and header:
• Close door.
• Measure door width at top.
• Mark a point at center of door and on header directly
above door. Draw a center line to connect points.
Find Header Bracket mounting height (Figure 4):
(Do not attach Header Bracket).
• Raise door, watching top edge of door and stop door
when its edge reaches its highest point.
• Measure distance ("H") from top edge of door to floor.
- For sectional doors, add 2-1/2" to"H" Mark a point
on center line. Bottom of Header Bracket will be
installed here.
- For one-piece doors, add 6" to "H" Mark this point on
center line. Bottom of Header Bracket will be
installed here.
HEADER
SECTIONAL DOOR
H
ONE-PIECE DOOR
........ \ii7 ...
NOTE
C
6
For both types of doors:
- If the ceiling in your garage is so low that there is
not at least a 3" space above the Header Bracket
mountingpoint, contact a Genie Factory
AuthorizedDealer.
If a door spring is in the way, place the Header
Bracket above the spring. Do Not move the door spring.
WARNING:
Door springs are under extremely high tension and should be
handled ONLY by a trained professional.
Check wall for a stud or a solid header at your mark:
(If checking a finished wall, a stud finder may be helpful).
• If location is above Header, a 2"x 6" board must be
screwed to studs beside your mark with at least two Lag
Screws and Flat Washers (not provided).
• Transfer your mark to new mounting board.
HEADER
H ÷ 6"
Figure 4 Find Highest Point of Travel
......................... L_I N ........................