Genie Directlift 2060 Manual De Funcionamiento Y Mantenimiento página 10

2060-3060 eng.qxd 11/9/05 11:02 AM Page 10
i
'\ b/
WARNING
• A moving grage door can cause serious injury or death.
• Keepthe path clear.
• Position the ladder to the side of the Power Head so it is
clear of all moving parts of the Opener and the door.
• Set the door Opener to use the minimum force needed
to open the door.
........ ki17.......
B OPEN ADJUSTMENT
• On front panel of Power Head find adjusting screw
marked "OPEN" (Figure 9).
• Gently turn screw counterclockwise until it stops.
- Very little force is required to turn adjusting screw.
• Press Wall Console to close garage door.
- Observe if door stops at"OPEN" limit switch.
If door is fully open--adjustment is finished.
- If door stops but is not fuly open,
a. Measure distance between bottom of door
top of door opening.
b. Move "OPEN" Limit Switch that same distance
toward Power Head.
- If door stops before reaching the"OPEN" Limit Switch
a. Slightly increase OPEN Force setting (clockwise).
- If door fails to move, see Troubleshooting Section,
pages 15.
C Run Door Opener
• Cycle opener a few times to double check settings.
Repeat adjustment steps as necessary.
........ ki17...
SITTIH6 <CI _U'_+{°"__ = Jl.= &_=
I,_IVIB,sI
I<iIIHCTlOH
NOTE
Limit Switch and Force Adjustments must be completed
before checking the contact reverse function (Figure 10 ).
A Open garage door using Wall Console.
B Lay a 2" x 4" board flat in center of doorway.
C Close door using Wall Console.
D Check that door stops and reverses within 2 seconds after it
contacts board:
• If door does not reverse, decrease Close Force until
door reverses.
• If door still does not reverse, move Limit Switch
toward door.
E Check Safe-T-Beam ® System operation:
• If beam is blocked, door will not close.
NOTE
The door must contact the 2" x 4" board before the Carriageactivates
the Close Limit Switch. If not, readjust the Close Limit Switch.
2" x 4" board
laid flat
Figure 10 Checking Contact Reverse
10
i
......................... L<I N ........................