Dometic SPX1200T Instrucciones De Montaje página 9

SPX1200T
I
NOTE
After installation of the system, the pre-set parameters on the system software
must be checked (chapter "Configuring the system software" on page 12).
6.2 Removing the roof hatch
Proceed as follows (fig. 6):
1. Remove all screws and fixings for the existing roof hatch.
2. Take out the roof hatch.
3. Remove the sealant around the opening so that the surface is clean and free
of grease.
I
NOTE
Dispose of all waste material, glue, silicon and seals separately. When doing
so, follow the waste disposal requirements applicable in your local area.
6.3 Preparing the unit fixings
➤ Drill out the 8 factory-made holes to a diameter of 8.5 mm (fig. 7).
6.4 Attaching the seal for the cab roof
A
NOTICE!
Ensure that the surface where the seal between the unit and the cab roof is to
be glued is clean (free of dust, oil, etc.).
1. Glue the sealing strip to the cab roof (fig. 9 A).
Follow the contour of the roof hatch opening. The join between the ends of
the seal should be at the back.
2. Apply a flexible, non-hardening butyl sealant (e.g. SikaLastomer-710) to the
join between the ends of the sealing strip and to the top edge of the sealing
strip (fig. 9 B).
EN
Installation
9