DeWalt DCMWP134 Manual página 60

EnGLIsh
Overheat Indicator (Fig. U)
• The overheat indicator
then blink when the batteries or motor is overloaded
during operation.
• The overheat indicator
when the module has reached a high temperature.
• To clear the overheat indicator
mower to cool down. When cooled, restart the mower and
resume cutting with the mower deck set higher.
Blade Sharpening Indicator (Fig. U)
The blade sharpening indicator
blades need service. Sharpen or replace the blades, refer to the
Blade Sharpening section in this manual.
Blade Reset Button (Fig. U)
nOTE: Ensure the battery packs
are installed before attempting to reset.
To clear the blade sharpening indicator
control panel 12 by pulling and holding the bail handle
the main handle 4 . Press and hold the blade reset button
until the blade sharpening indicator
Starting Mower (Fig. Q—T)

DANGER: Sharp moving blade. Never attempt to
override the operation of the switch box and safety
key system as serious injury could result.

WARNING: Ensure self drive is disengaged before starting
the mower
nOTE: Mower is operational when the battery packs
safety key are installed.
6
1. Lift and hold the battery port cover
battery port 38 .
2. Slide a battery pack
26
audible click is heard. Repeat this process for the second
battery pack 26 .
nOTE: Ensure both battery packs are fully seated and fully
latched into position before starting mower.
3. Close the battery port cover
cover 19 is fully closed before starting the mower.
4. Insert safety key into the key slot
6
handle , until it is fully seated inside of the key slot
4
shown in Fig. T.
5. To power on the control panel
handle to the main handle
8
6. To start the mower blades, continue to hold the bail
handle 8 to the main handle
button 11 .
58 58
will illuminate amber and
13
13 will illuminate red and then blink
13 , allow the batteries and
16 will illuminate when the
26 and safety key 6
, power on the
16
16 turns off.
26
19 up to expose the
into the battery port until an
38
19 . Ensure the battery port
, located on the main
50
12 , pull and hold the bail
.
4
4 and then press the power
nOTE: Once the mower starts you can release the
power button
bail handle
to stay running.
7. To turn the mower OFF, release the bail handle

WARNING: Never attempt to lock a switch or bail handle
in the ON position.
nOTE: Once the bail handle
position it will activate the "Automatic Braking Mechanism".
The motor is braked and the mower blades will stop rotating in
three seconds or less. If mower blades rotate longer than three
seconds, discontinue using mower and have it serviced.
DCMWSP156 ONLY
Self Drive System (Fig. V)

DANGER: Sharp moving blade. Never attempt to
override the operation of the switch box, the self
drive system or the safety key system as serious
injury could result.
Your mower DCMWSP156 is equipped with a self drive system
which functions independently of the mower blades.
1. To use self drive, press the self drive lever
main handle
2. To turn off self drive, release the self drive lever
nOTE: During cutting, at times it may be easier to maneuver
around an object, such as a tree or plants, with the self drive off.
The mower can easily be used with the self drive system off.
8 to
DCMWSP156 ONLY
17
Speed Adjustment Dial (Fig. W)
Your DCMWSP156 mower is equipped with a speed adjustment
dial 10 located next to the control panel
the speed adjustment dial
the self drive system propels the mower. Choosing a lower
number propels the mower at a slower pace. Choosing a higher
number propels the mower at a faster pace.
1. To increase the speed of the self drive system, rotate the
speed adjustment dial
and
nOTE: The speed adjustment dial
higher number.
2. To decrease the speed of the self drive system, rotate the
speed adjustment dial
nOTE: The speed adjustment dial
lower number.
Mower Overload
To prevent damage due to overload conditions, do not try to
remove too much grass at one time. Slow down your cutting
pace, or raise the cut height.
Mowing Tips (Fig. A)
as
50

WARNING: ALWAYS INSPECT AREA WHERE MOWER
IS TO BE USED AND REMOVE ALL STONES, STICKS,
WIRE, BONES, AND OTHER DEBRIS WHICH MIGHT BE
THROWN BY THE ROTATING BLADE.
11 , but you must continue to hold the
8 to the main handle 4 for the mower
8 has returned to the original
4 .
12
10 indicate how quickly or slowly
towards the rabbit icon
10
10 will display a
towards the turtle icon
10
10 will display a
8 .
9 towards the
.
9
. The numbers on
.
40
.
41